NiteSite spotter rtek xe User Manual
        |
Congratulations on the purchase of your NiteSite product! Before you start to use the NiteSite systemplease carefully read these instructions to enjoy optimum performance and a long service life.There are three products in the RTEK spotting adaptor range for you to enjoy. The XE, XW and XV.Please read the relevant information regarding your product purchase contained in this instructionmanual. NiteSite spotting adaptor product’s viewing ranges expressed are dependent on the spottingscope and weather conditions.Intended useThe NiteSite products are add on devices for use with an existing scope. They are also foruse in daylight. During darkness the NiteSite products will achieve a night vision identificationrange of up to 500 metres depending on the model purchased, weather conditions and optic.NiteSite Ltd does not bear responsibility for the use of this product in countries or territories wherethe law prohibits its use. It is the sole responsibility of the operator to comply with the laws andregulations of the country or territories where the NiteSite add on devices are used.Your NiteSite productClick on your model below to see the respective products kit contents1Operating instructionsStep 1Place the Saddle bracket round the spotting scope, feed the velcro ribbon through the saddlebuckle and place the strap back on its self so that the saddle is firmly in place on top of the spottingscopeStep 2Slide the illuminator module into the “T” slot on the saddle bracket.Step 3Fit the spotting scope to the NiteSite aluminium bracket using the fixing screw provided. (spottingscope bracket and fixing screws purchased separately)Step 4Push the flexible sleeve over the eye piece of the spotting scope. Push the camera in to the flexiblesleeve then fix the camera to the aluminium bracket. Make sure the camera and sleeve are fixed sothat the camera module is concentrically viewing down the spotting scope eye piece.Step 5Fit the battery pack in place (the XE model comes with a 6000 mAh battery in a pouch thatmust be fitted to the spotting scope and not the flexible sleeve.)Step 6Connect the illuminator module to the camera moduleStep 7Connect the battery to the camera module and switch on the NiteSite system with the button on theback of the camera module |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine