Noctua NA-FD1 Installation Manual
  |
NOCTUA NA-FD1INSTALLATION MANUALScan this code to displaymultilingual manuals onyour phone.Required mounting parts:7x foam spacers:NA-FDS1 (3mm), NA-FDS2 (4mm), NA-FDS3 (5mm),NA-FDS4 (6mm), NA-FDS5 (7mm), 2x NA-FDS6 (10mm)4x NA-FDB1steel bolts4x NA-FDT1plastic tubes(16 included in total forfuture installations)Required tools (not included):Toothpick orsimilar straight,thin objectScissorsPhilips PH2head screwdriveror equivalentPencilRuler ortape measureVideo instructions!For video instructions, please scan this code or accesshttps://noctua.at/en/na-fd1/videoPlease first fully assemble your system, installing the NH-L9cooler according to the installation manual that came withthe heatsink. Then, take a toothpick or a similar straightobject that is thin enough to fit through the holes locatedabove the cooler in your case’s perforated panel. Stick thisobject through the panel, right above one of the corners ofthe NH-L9’s fan, until it touches the fan’s integrated anti-vibration pad at a 90° angle.Mark the position of the panel on the toothpick using apencil.Measure the distance between the marking and the tip ofthe toothpick. Then, measure the thickness of the paneland deduct it from the first measurement result in order todetermine the target height of your fan duct.The NA-FD1 contains the following spacers:3mm, 4mm, 5mm, 6mm, 7mm, 10mm (2x)Selecting the foam spacers210mm7mm6mm5mm4mm3mmNumber of markings = thickness in millimetersPlease select the spacer(s) according to the target heightdetermined in step 1. The spacers can be combined toany height between 5 and 45mm in 1mm increments. Forexample, if you have measured a target height of 16mm,please combine 1x 10mm and 6mm. If your target height is25mm, please combine 2x 10mm and 5mm. 5mm is theminimum height due to the height of the mounting bolts.For optimal performance, there should be no gap betweenthe spacers and the panel after installation. If your case panelis installed by sliding it onto the case sideways (perpendicularto the cooler’s direction of airflow), accepting a small gap of1-2mm may be necessary so that the panel does not bendthe top spacer during installation.90° angleMeasuring the gap between the fanand the case panel1Target height of fan ductMarked position of panelThickness of panel |
Related manuals for Noctua NA-FD1
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine