Noctua NH-D14 Installation Manual
NH-D14 | Installation Manual INTELRemoving the mainboardStep 1:In case you want to use the cooler on an assembled system,you first have to remove the mainboard from the case in orderto be able to install the supplied backplate.Caution: On LGA1366 and LGA1156, the supplied backplatewill install over the mainboard’s stock backplate, so the main-board’s stock backplate must not be taken off.Required mounting parts:First put the four bolts into the holes appropriate for yourmainboard’s CPU socket.Setting up the backplateStep 2:Thank you very much for choosing a Noctua cooler. Thismanual will guide you through the installation process ofthe SecuFirm2 tm mounting system step by step.Prior to installing the cooler, please consult the compat-ibility list on our website and verify that the cooler is fullycompatible with your motherboard. Should you encounterany difficulties, please check the FAQs on our website anddon’t hesitate to contact our support team at support@noctua.at.Noctua cannot be held responsible for any damage or lossescaused by compatibility issues.Multilingual versions of this manual are available on ourwebsite: www.noctua.atCaution: Please verify that all four bolts are put into the ap-propriate holes fully pushed in.Step 4:Installing the mounting barsFirst put the plastic spacers onto the bolts, then add the mount-ing bars.Noctua NH-D14 INTELInstallation Manual4x plastic spacers 4x thumbscrews1x 3-in-1 Intel backplate4x bolts for backplate 2x mounting barsLGA1366 (80mm)LGA1156 (75mm)LGA775 (72mm)For use on LGA1366 and LGA1156 mainboards, please re-move the rubber inlay. Make sure that the rubber inlay is inplace for LGA775.LGA1366 & LGA1156 LGA775Caution: On LGA1156, please make sure that the two cuts inthe supplied backplate align with the screws of the mainboard’sstock backplate.Caution: Choose the alignment of the mounting bars accordingto the desired final orientation of the cooler:Step 3:Attaching the backplatePlace the backplate on the rear side of the mainboard so thatthe bolts stick through the mounting holes.1x LGA775 rubber inlay |
Related manuals for Noctua NH-D14
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine