AG 3000 Quick StartP/N 200-1021-001-M | 1 |Copyright © 2005 Nomadix, Inc.This document provides instructions and reference material for getting started with the NomadixAccess Gateway 3000 (AG 3000) product. If you have any problems, please contact ourtechnical support team at +1.818.575.2590, or email: support@nomadix.com.Start Here1. Unpack the AG 3000 and place the product on a flat and stable work surface.2. Connect the power cord.3. Connect the DB9 female-to-female (NULL) serial cable (6ft. length) between theproduct’s “serial port” and your computer.4. Power up your computer and turn on the product.5. Start a HyperTerminal session to communicate with the AG 3000 via the product’s serialinterface. Use the following configuration settings for your session:Bits per Second Data Bits Parity Stop Bits Flow Control9600 8 None 1 None6. Log in to the Command Line interface:The default for both the Username and Password is admin.7. Go to the “Configuration” section on the next page and configure the AG 3000 for yournetwork.