Nordic Start NS-1000 SH User Manual
Will automatically lock the doors when the key is turned to the on positionand the brakes are pressed.When the ignition key is turned to the off position, the doors willautomatically unlock.PROGRAMMING OPTIONSPROGRAMMING OPTIONSPROGRAMMING OPTIONSPROGRAMMING OPTIONSThe following can be programmed by your dealer:• Engine run time: 5, 15 or 25 minutes.• Number of retries: 2, 3 or 4 times• Maximum crank time: 6, 8 or 12 seconds• Child proof feature• Trunk release or Garage door control.• Idle mode feature.DIAGNOSING PROBLEMSDIAGNOSING PROBLEMSDIAGNOSING PROBLEMSDIAGNOSING PROBLEMS Poor transmitting rangeThere are many factors which affect operating range. Some of these are:• Battery condition• Operating environment (Downtown RF noise)• Metal: any type of metal will affect operating range. Range in acrowded parking lot will be significantly lower than open space.• Transmitter orientation: always hold the transmitter high;approximately shoulder height. Holding the transmitter under the chinwill improve performance. Try it! Engine does not startIf the engine does not start, check the following:• Is the transmitter LED working? If not, check the battery .• Are you pressing the transmitter long enough? Press the transmitteruntil the parking lights activate.• Check the valet switch. When the power is turned ON, the parkinglights will flash twice to confirm power up.VALET MODEVALET MODEVALET MODEVALET MODEAutostart is equipped with a valet switch (ON/OFF) make sure that allusers of the vehicle know the location of the switch.* To put the unit into Valet mode, simply turn the under dash switch toOFF (system should now be in valet)BASIC REMOTE OPERATIONSBASIC REMOTE OPERATIONSBASIC REMOTE OPERATIONSBASIC REMOTE OPERATIONSThe remote control unit has two buttons. Button 1, is used for remote keyless entry.Button 2, serves to start the vehicle. Button I & II, Is for the convenience ofremote trunk release.To start the car by remote, you must ensure that the hood is closed and that theValet switch is in the ON position. Press button 2, for about 1 second (or 4 to 5 ifthe Child Proof feature was enabled by your installer). Once the button has beenpressed the parking light will come on to inform you that the unit has received yoursignal, and has begun the start process. The car should be running after about 5 sec.The vehicles parking lights will stay on the entire pre-programmed run cycle.NOTE: Do not continue to press the remote once the parking lights activate.Pressing the remote continuously for 4 seconds will activate “Cold Weather Mode”and will Not start the engine.If the vehicle doesn’t start, the Autostart will shut off, wait a few seconds, then re-try to start the engine again. The Autostart will try to start the engine a total of 2,3or 4 times (programmable) before giving up.With the vehicle running under remote control, enter the vehicle. Insert the keyin the ignition and turn the key to the “ON” position. Do not turn the key to the“START” position with the engine running, this will cause the starter motor toreengage.NOTE: Do not forget to leave the heather or air conditioner turned on beforeleaving your vehicle. So that your vehicle can be “PRE-WARMED” or “PRE-COOLED” by remote control.REMOTE DOOR LOCKSREMOTE DOOR LOCKSREMOTE DOOR LOCKSREMOTE DOOR LOCKSIf your system was installed with remote door locks, you will have the convenienceof remote keyless entry.To UNLOCK you doors, press and hold button 1 for aboutUSER-GUIDEUSER-GUIDEUSER-GUIDEUSER-GUIDENS-1000 SHNS-1000 SHNS-1000 SHNS-1000 SH |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine