Nordic Start NS-1003 User Manual
PROGRAMMING OPTIONSYour installer can program the following:x Engine run time: 4, 15 or 25 minutes.x Number of retries: 2, 3 or 4 times.x Maximum crank time: 6, 8 or 12 seconds.x Child proof feature.x Trunk release or Garage door control.x Idle mode feature.x Secure Lock.DIAGNOSING PROBLEMS Poor transmitting rangeThere are many factors that affect operating range. Some of these are:x Battery conditionx Operating environment (Downtown RF noise)x Metal: any type of metal will affect operating range. Range in acrowded parking lot will be significantly lower than open space.x Transmitter orientation: always hold the transmitter high;approximately shoulder height. Holding the transmitter under the chinwill improve performance. Try it! Engine does not startIf the engine does not start, check the following:x Is the transmitter LED working? If not, check the battery .x Are you pressing the transmitter long enough? Press the transmitteruntil the Parking lights activate.x Check the Valet switch. When the power is turned ON, the Parkinglights will flash twice to confirm power up.VALET MODENordic Start is equipped with a Valet switch (ON / OFF) make sure that allusers of the vehicle know the location of the switch.* To put the unit into Valet mode, simply turn the under dash switch toOFF (system should now be in Valet)BASIC REMOTE OPERATIONSThe remote control unit has three buttons. Button 1 (LOCK) is used forremote keyless entry. Button 2 (START) will start the vehicle. Button 3(TRUNK) is for the convenience of remote trunk release.To start the car by remote, you must ensure that the Hood is closed and thatthe Valet switch is in the ON position. Press START, for about 1 second (or 4to 5 if the Child Proof feature was enabled by your installer). Once the Buttonhas been pressed the Parking lights will come ON to inform you that the unithas received your signal, and has begun the start process. The car should berunning after about 5 sec. The vehicles Parking lights will stay on the entirepre-programmed run cycle.NOTE: Do not continue to press the remote once the Parking lights activate.Pressing the remote continuously for 4 seconds will activate “Cold WeatherMode” and will Not start the engine.If the vehicle doesn’t start, the Nordic Start will shut OFF, wait a few seconds,and then re-try to start the engine again. The Nordic Start will try to start theengine a total of 2, 3 or 4 times (programmable) before giving up.With the vehicle running under remote control, enter the vehicle. Insertthe key in the Ignition and turn the key to the “ON” position. Do not turnthe key to the “START” position with the engine running, this will causethe starter motor to reengage.NOTE: Do not forget to leave the heather or air conditioner turned ON beforeleaving your vehicle. So that your vehicle can be “PRE-WARMED” or“PRE-COOLED” by remote control.REMOTE DOOR LOCKSIf your system was installed with remote door locks, you will have theconvenience of remote keyless entry. To UNLOCK you doors, press and holdButton 1 for about 1 sec. Once the doors have unlocked the Parking lightswill flash twice to confirm that the doors are unlocked. (Also disarming yourstarter kill.) To LOCK your doors, press Button 1 on your remote. When thedoors have locked, the Parking lights will flash once. (Arming the starterkill.)USER-GUIDENS-1003/433Rev: 2.01 La – 08/09/01 Manufactured in Canada by NORDICSTART4 |
Related manuals for Nordic Start NS-1003
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine