2GIG® GC3/GC3e Security & Automation SystemGC3/GC3e User’s Guide10023750 BWARNING: OWNER’S INSTRUCTION NOTICENot to be removed by anyone except occupant

Nortek 2GIG GC3E-345-K1 User Manual

Introduction

Document Conventions

Planning the Installation

Internal Components

Additional Accessories

Important Information

Installation Steps

Installing the System

Mount the GC3 Panel's Backplate

Connect an External Alarm Sounder

Connect the Hardwire Loops

Connect the Power Wires

Control Panel Wiring Diagram

Terminal Blocks Wiring Diagram

Connect the Backup Battery

Install the Retaining Wall Bracket and Connect the AC Power Supply

Update the GC3 Panel Firmware

Navigate to the Installer Toolbox

Attaching to a Wireless Network

Wired (Ethernet)

network test

Programming Sensors and Peripherals

Next Steps

Program a Wired Zone

Program a Keyfob

Program a Keypad

Panel Programming

Q6: Entry delay 2, in seconds (30-240)

Q10: Police emergency key

Q16: Allow quick exit

Q24: Temperature display units

Q29: CS lack of usage notiﬁ cation time, in days (0-255)

Q35: Broadband network failure reports

Q42: Trouble doesn't sound at night

Q46: Time to detect AC loss, in minutes

Q54: AC restore reports to CS

Q62: Smart test reports

Q70: Main Panel Sounder Follows

System Conﬁ guration Reference

transmission delay

Panel Programming Reference

Features to Limit False Alarms

Image Sensor

Add a New Device

Remove a Device

Check the Network

View All Devices

Associating Z-Wave Devices

Reset the Controller

Learn Controller

Testing the Installation

Verify the Radio Status

Limited Warranty

2GIG GC3

Technical Support

Limitations of Alarm Products

Touchscreen Basics

System Status Messages

Using the Inbox

Using Bookmarks

Using the System Menus

Responding to Trouble Alerts

Burglary Protection

Sample Burglary Alarm Plan

Arm the System

Force Bypassing

Use the Quick Exit Button

Transmit a User Duress Report

In the Event of a Burglary Alarm

Fire and Carbon Monoxide Protection

Emergency Action Plan

Emergency Features

Activate a Manual Panic, Fire, or Emergency Alarm

Remote Control

Lights

Garage Doors

Rooms

Smart Areas

System Info and Usage

System Info

Dealer Info

System Settings

Sounds

Bypass Sensors

Smart Home Settings Menu

Screen

Language

System Tests

Broadband

Firmware Update

Wired Network (Ethernet)

Replace the GC3e Cellular Radio Module

Chimes

Smart Areas Settings

Welcome to the GC3 System

Arm the System (Away Mode)

Disarm the System

If You Need to Use the Duress Code

Manual Alarms

Change the Master User or Duress Code

Edit a User Code

View Smart Areas

Network Settings

2GIG GC3e

2GIG GC3E-345

2GIG GC3E-345-K1