Nortek Gocontrol WF00Z-1 Instructions Manual
1GOCONTROL SMART LEAK DETECTORThe GoControl™ family of Z-Wave® certifi ed wireless lighting products (smartLED bulbs, switches, dimmers, outlets, plug-in modules), security devices(alert sounder, motion sensor, and door/window sensor), and control products(garage door controller and thermostat) bring a new level of intelligent wirelesscapability to commercial and residential environments.The Z-Wave wireless protocol is an international wireless standard for remotehome automation, security and other applications. Embedded in each device,the Z-Wave smart chip enables two-way RF communication among hundredsof Z-Wave enabled devices, allowing products and services from multiplemanufacturers to work seamlessly.The WF00Z-1 Smart water detector is simple to set up and provides an alertwhen there is water present at specifi c high risk locations; water heater, undersinks washing machine.GoControl Z-Wave products are easy to install, are Z-Wave Plus certifi ed, andallow dealers to create an integrated wireless network with nearly limitlessexpansion and interoperability with security, energy management, homeentertainment, appliances, and more.For indoor use only. Retain instructions for future use.Z-WAVE PLUS FEATURESThe WF00Z-1 contains a Z-Wave 500 Series Module that supportsZ-Wave Plus® features. A Z-Wave certifi ed portable or stationary Controllercan communicate with the Z-Wave 500 Series Module.Depending on the capability of the Controller or gateway software, the followingoperations will be performed by FloodZ. Refer to the controller or gatewaymanual for details.• Send an alert if water is present.• Add or Remove FloodZ.• Over-the-air firmware update by the gateway or static Controller.INSTALLATIONThe WF00Z-1 consists of the transmitter and a sensor that is connected to itby a 7 foot long wire. The sensor can attach to the fl oor or wall with the twoscrews (supplied).1. Add the WF00Z-1 to a Z-Wave network (see reverse side).2. Use two screws provided to attach the fl ood sensor to the fl oor or wall in thelocation where flooding is most likely to occur.3. Use two screws or the double-stick tape supplied to attach the transmitterto the wall, above the sensor level.✓ NOTE: Position the WF00Z-1 in a location where it would not likely beaffected by fl ooding or have its wireless signal blocked by metal appliances.WF00Z-1Z-Wave Radio Frequency (RF) ControlledFlood DetectorNOTE: This unit must be added to the Network only where it will be permanently installed. The proper operation of this node in themesh network is dependent on it knowing its location with respect to other nodes. You cannot “test bench” confi gure this unit, then install.WF00Z-1TRANSMITTERFLOODSENSOR7-FOOTCABLEINDICATORWF00Z-1TRANSMITTERFLOODSENSORATTACH FLOODSENSOR WITHTWO SCREWSSCREW HOLES FORWALL OR FLOORMOUNTINGFLOORATTACH TRANSMITTERWITH TWO SCREWSOR ADHESIVE TAPEZ-Wave® and Z-Wave Plus® are registered trademarks of Sigma Designs andits subsidiaries in the United States and other countries.Covered by one or more claims of patents: http://sipcollc.com/patent-list/and http://intusiq.com/patent-list/Terms and Conditions pertaining to the sale of this Nortek Security & Controlwireless mesh network product are available athttp://nortekcontrol.com/terms_conditions.php |
Related manuals for Nortek Gocontrol WF00Z-1
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine