Nortek MG1 Series Installation Instructions Manual

Nortek MG1 Series Installation Instructions Manual Manual pdf 1 page image

MG1 SeriesDownflow, Direct Vent (Sealed Combustion)Forced Air Gas FurnacesINSTALLATION INSTRUCTIONSWARNING / AVERTISSEMENTFIRE OR EXPLOSION HAZARD• Failure to follow safety warnings exactly couldresult in serious injury, death or property damage.• Installation and service must be performed bya qualified installer, service agency or the gassupplier.• Do not store or use gasoline or other flammablevapors and liquids in the vicinity of this or anyother appliance.RISQUE D’INCENDIE OU D’EXPLOSION• Le non-respect des avertissements de sécurité pourraitentraîner des blessures graves ou des dommagesmatériels importants.• L’installation et l’entretien doivent être effectués parun installateur qualifié, un organisme de service ou lefournisseur de gaz.• N’entreposez pas ni n’utilisez de l’essence ni d’autresvapeurs ou liquides inflammables dans le voisinage decet appareil, ni de tout autre appareil.WHAT TO DO IF YOU SMELL GAS• Do not try to light any appliance.• Do not touch any electrical switch; do not useany phone in your building.• Leave the building immediately.• Immediately call your gas supplier from aneighbors phone. Follow the gas suppliersinstructions.• If you cannot reach your gas supplier, call the firedepartment.QUE FAIRE S’IL Y A UNE ODEUR DE GAZ• N’essayez d’allumer aucun appareil.• Ne touchez à aucun interrupteur électrique; n’utilisezaucun téléphone dans le bâtiment.• Évacuez l’immeuble immédiatement.• Appelez immédiatement le fournisseur de gaz en employantle téléphone d’un voisin. Respectez les instructions dufournisseur de gaz.DO NOT DESTROY. PLEASE READ CAREFULLY & KEEP IN ASAFE PLACE FOR FUTURE REFERENCE.CAUTIONHUD Manufactured Home Construction and SafetyStandards (3280.714) prohibit the use of noncertifiedair conditioning or heat pump equipment withthis furnace. It is strongly recommended thatmanufactured housing air conditioning componentsfrom Nortek Global HVAC be selected to providea matched system specifically designed to meetthese requirements.The cutting, splicing or modifying of any internalelectrical wiring may void product warranties andcreate a hazardous condition. Failure to complywith these standards could also provide inadequateheating or cooling performance and cause structuraldamage to a manufactured home.Please contact your local distributor for help. Adirectory of Nortek Global HVAC factory authorizedservicers is located in the furnace homeownerpacket.Reference: HUD Manufactured Home Constructionand Safety Standards 3280.714.For installation in:• Manufactured Homes• Recreational Vehicles, Park Models, &Manufactured Buildings• Modular Homes / Buildings