Nortel BayStack Instant Internet 100-S Install Manual

Also see for BayStack 100-S: Reference Install guide Release note Using User guide

Nortel BayStack Instant Internet 100-S Install Manual Manual pdf 1 page image

Wall Mounting the Instant Internet 100-S Unit*211487-A*You can mount the BayStack Instant Internet 100-S unit on any drywall, wood, or cement wall that isat least 0.39 inches (10 mm) thick and is capable of supporting the combined weight of the unit andattached cables (approximately 11 pounds or 5 kg).A set of brackets, self-tapping (3.5x16) drywall screws, and (3x18) plastic expansion lugs (Figure 1)has been included with the Instant Internet 100-S unit. You will need a Phillips screwdriver, which isnot included with the unit. If you are mounting the unit on a drywall or cement wall, you will need adrill and a 1/4-inch drill bit, which are also not included with the unit. If you are mounting the uniton a wood wall, you will need a #6 wood screw (not included) that is long enough to penetrate thewood by at least 1/2-inch.Figure 1 provides a template for you to use as a guide for placing the screws in the wall.Figure 1 Template for correct placement of holes in the wallTo use this template:1 Trace the illustration onto another piece of paper.2 Cut out the tracing, making sure to cut out the holes provided for the screws.3 Place the tracing against the wall where you would like to mount the Instant Internet 100-S unit.4 Using a pencil, trace inside the holes that you have cut out to mark where the screws should go.5 Remove the tracing and place the screws where you have marked.10119EA

/ 2

Related manuals for Nortel BayStack 100-S