More on your T7316E telephoneAudio cluster buttons© Mute buttonTurns the microphone off or on when you are on a call.Handsfree buttonFor more information on using the handsfree feature,refer to the “Handsfree calls” section in this card.¬ Headset buttonTurns the headset mode on.≤ Feature buttonStarts or ends a feature.≥ Hold buttonPlaces calls on hold.Memory buttonsMemory and line buttonsIndicatorsAppear next to active line and memory buttons.Number cardWrite your extension number on this card.Feature card plateStorage compartment for your feature card.GHIJKLMNT7316E Telephone User Card1-800-4 NORTELwww.nortelnetworks.com© 2003 Nortel NetworksP0603479 02Printed in CanadaABCDEFHJKLMJKGINCord connectionsWall mount without a telephone stand1Desk mount optionRoute line cord through the stand.Headset optionConnect cord toheadset.Connect cordto handset.Connect line cordto wall jack.23Slide feature card plate down.Press here to remove the stand.Place the telephone ontothe wall mount plate andslide it down.Connect line cord towall jack.12Connect cords to the telephone,refer to “Cord connections”illustrations.Your T7316E telephoneTelephone lightFlashes for incoming calls.Lights up when Message Waiting Indication (MWI) issupported by system software. Contact your systemadministrator for more information.Adjustable tilt displayShows the time and date, call and feature information.Display buttonsThe label for display buttons appear in capital letterson the bottom of the display. Display buttons changewith each feature you use.® Release buttonEnds an active call or feature.Dial pad√ Volume controlAdjusts the handset, handsfree, headset and ringervolume.ABCFeature messageDisplay buttonContrast level 2Display button labelDOWN UP OKDEFWall mount with a telephone standMount the telephoneonto the screws andslide it down.Press here to remove the stand.1Mount the stand as shown.Use the key hole slots on the standto mark the location for the screws.key hole slots23Connect line cord towall jack.Connect cords to the telephone,refer to “Cord connections”illustrations.Tighten screws for a secure fit.Display contrast levelAdjust the contrast of your display.1. Press ≤•‡.2. Press UP or DOWN to view the levels.3. Press OK to select a level.Language choice≤•fi‚⁄Select Primary Language for the telephone display.≤•fi‚¤Select Alternate Language for the telephone display.≤•fi‚‹Select Alternate Language 2 for the telephone display.≤•fi‚›Select Alternate Language 3 for the telephone display.Ring typeSelect a different ring for your telephone.1. Press ≤•fl.2. Press ⁄, ¤, ‹, › or NEXT to hear the differentring types.3. Press OK to store the ring type.Telephone setup