NorthEast Monitoring DR400 Quick Start Manual
Also see for DR400: User manualQuick start guideQuick start guideQuick start guideUser manual
  |
DR400 Quick Start GuideTo purchase more patch electrodes contact your distributor or go to www.nemon.comSTEP DESCRIPTION STEPS/HINTS1 Fully charge theDR400 Use a power source (not the PC) to charge the DR400 Remove from power source when orange light stops blinking2 Enter Patient IDusing PCPatchUtility If you have not already done so, save and delete previouspatient’s data from the DR400 using the PCPatch utilitybefore entering new Patient ID3 Prepare patient Determine the best location to attach the patch and optionallead wire onto the patient, but do not attach at this time Prepare the patient’s skin. If the patient has hair in any of thepatch site, shave it with a safety razor. Use an alcohol padand rub the sites briskly until the skin reddens. Let the skin airdry before proceeding.4 Prepare DR400and attach topatient Attach 1-lead electrode patch (1CH) or 1-lead electrode patchw/ lead wire (3CH)to the DR400 recorder Remove backing from leads and attach firmly to patient5Start Recordingby holding theDR400 “EVENT”button downuntil green lightgoes out If you so choose, start the PCPatch utility before starting theDR400 to confirm start up and observe lead quality The DR400 will flash green for 30 seconds at the start of therecording At any time, press EVENT button again to transmit Bluetoothsignal to view ECG via PCPatch utility6 Stop Recordingand Upload datafor analysis Remove from patient and plug DR400 into the PC USB cableand the DR400 will stop recording after 2 minutes Start PCPatch utility to save DR400 data to HE/LX patientdirectory Open HE/LX Analysis to view and analyze patient dataThe PCPatch Utility Hook-up GuideDownload PCPatch at www.nemon.comand install on PC where analysis softwareis installed.Note: You do not need a Bluetooth USBAdapter to use the DR400. The adapter is onlyrequired to view ECG using the PCPatch utility. Contactyour distributor to find out more about this feature.1-lead electrode patch(1CH)Snap GuideIf using the 1-lead electrode patch with the optionalECG lead wire:• Attach the ECG lead wire first• ECG lead wire attaches tosnap closest to USB port The lead plastic should coverthe USB portTo attach the 1-lead electrodepatch for 3CH recording: Patch goes on diagonally Press down firmly so that allsnaps are locked in place 1-lead patch w/ lead wire(3CH)Copyright 2019Last updated: July 19, 2019NEMM049 - Rev-A - EnglishYou must download and install the PCPatch Utility atwww.nemon.com before getting started. |
Related manuals for NorthEast Monitoring DR400
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine