Notifier CAB-5 Product Installation Document

Notifier CAB-5 Product Installation Document Manual pdf 1 page image

CAB-5 Series CabinetsProduct Installation DocumentPN LS10244-000GE-E:A 10/13/2021 ECN: 164751 GeneralAll cabinets are fabricated from 16 gauge steel. The cabinet consists of two basic components: a backbox and a locking door. The backbox and doorare sold separately.The key-locked door is provided with a pin-type hinge, two keys, and the necessary hardware to mount the door to the backbox. The backbox has beenengineered to provide ease-of-entry for the installer. Knockouts are positioned at numerous points to let the installer bring conduit into the enclosureeasily. Doors can be mounted on the left or right-hand side. The same hinge works in both configurations, so that this choice can be made in the field.The door opens 120°.Cabinets are available in five sizes: A, B, C, D, and E. The outside dimensions are noted on each enclosure diagram. “A” size accommodates one chas-sis and two 26 AH batteries. “B” size accommodates two chassis and two 26 AH batteries. “C” size accommodates three chassis and two 26 AH bat-teries. “D” size accommodates four chassis and two 26 AH batteries. “E” size accommodates five chassis and two 26 AH batteries. A trim ring optionis available for semi-flush mounting.2 Before You BeginThe option of mounting doors in either a left/right hand configuration will aid in installation andservice when two control panels are mounted in a confined area or side by side (as shown). In thismanner the doors can be opened “barn door” style, permitting an open work space.IMPORTANT: Attach the hinges to the backbox before any equipment is installed. With chassisinstalled, space is limited.3 Door Assembly InstructionsHinges can be either left or right hand mounted. Doors are shipped for left hand mounting. For right hand mounting, remove cladding (trim on dooredges) by removing the #8 keps nuts on the inside of the door frame. Pull cladding outward and down to remove. This will expose the hole for the key-lock. Rotate the cladding to opposite sides and reinstall.1. Install the hinge brackets into the top, middle (if applicable), and bottom positions of the side of the backbox to be hinged. Secure the brackets tothe studs in the backbox with the #8 hex nuts provided.2. Insert the top door hinge into the top hinge bracket and secure by sliding a hinge pin down from the top.3. Secure the middle (if applicable) and bottom hinges with hinge pins.4. Install the lock tab on the opposite side of the hinges. Insert lock tab into backbox over the PEM studs on the inside. Secure with two #8 hex nuts.5. Install the snap-in lock mechanism by pressing it into the hole on the front of the door, clicking it into place.NOTE: When the door is left-hand mounted, the dress panel cannot be opened when thedoor is at less than a 90° angle to the cabinet. If you are using the left-hand mounting option,be sure that the door can open at least 120°. This is especially important if the cabinet is to bemounted in a closed area, such as a closet or utility room. When wiring annunciators or optioncards on the dress panel, make sure to also allow extra wire so the dress panel can openfully.hinge bracket securedby two #8 keps nutshinge pinlock tablock tab secured by two#8 keps nuts inside backbox