HOW TOINSTALL YOURItem # CH-1000ADJUSTABLE DRINK HOLDER1 23 4WHAT’S IN THE BOXa. (1) Folding Cup Holderb. (1) Assembly Mount Setc. (2) Assorted Rubber Matsd. (1) Screw & Washer Seta. b. c. d.TOOLS NEEDEDPhilips ScrewdriverPeel off adhesive on back of rubbermat, and wrap around the locationwhere cup holder is to be installed(Figure 1).NOTE: For 1” tubing, use thin rubbermat. For 7/8” tubing, use thick rubbermat. For 3/4” tubing, use both thinand thick rubber mat (cut away extra).Attach folding cup holder oninner plastic gear and ensure thebase of the cup holder is parallelto the ground (rotate cup holderto adjust along gear if needed).Secure with washer and smallscrew (Figure 3).Place the assembly mount set around therubber mat to secure position. Ensure thatinner plastic gear of the mount faces the sidethe cup holder will attach to (Figure 2). Insertthe two long screws through the back andtighten.Drink holder is designed to collapse down toconvenient size (Figure 4). Swing the clamps down,and flip up the base to fold the drink holder.Drink holder can be adjusted by sliding the twoclamps to the appropriate size.Figure 1Figure 2Figure 3 Figure 4rubber matinner plasticgear21*Updated November 22, 2016Quick installation