G3 SeriesEtherNet/IPTM DLRTechnical Manual

Numatics G3 Series Technical Manual

About EtherNet/IP

G3 Introduction

G3 Electronics Modularity

Pneumatic Valve Manifold

Manifold Connectors

Z-Board™ Connectors

Z-Board™ and Ribbon Cable Example

Z-Board™ with Valve Side Sub-D Example

Communication Module

Communication Module Description

Connector Pin-Outs

Electrical Connections

Power Consumption

External Fuse Sizing Chart

Diagnostics

Output Short Circuit Protection

G3 Graphic Display

IP Address Sub-Menu

Subnet Mask Sub-Menu

DHCP-BOOTP Sub-Menu

MAC ADDR Menu

Advanced Settings - I/O Diag. Menu

Advanced Settings - Diagnostic Word

Advanced Settings - Fault Action

Advanced Settings - Idle Action

Advanced Settings - Brightness

Factory Defaults

Diagnostics - Self Test Mode

Diagnostics Cont

Error Messages

MCM – Manual Configuration Module (Optional)

DIP Switch Settings

ARM – Auto Recovery Module (Optional)

Distribution

Sub-Bus Distribution Modules

Sub-Bus Valve Module

Digital I/O Module Rules

I/O Module Descriptions and Menus

Digital Input Modules

Two Digital Inputs per Connector – M12 Female Modules

Sixteen Digital Inputs – Terminal Strip Modules

Digital Output Modules

Two Digital Outputs per Connector - M12 Female Modules

Digital Input/Output Modules

Valve Side Digital Output Modules

Analog I/O Modules

One Analog Input per Connector – M12 Female Modules

One Analog I/O per Connector – M12 Female Modules

I/O Module(s) Wiring Diagrams

EDS File

Home

Node Configuration

I/O Force and Test

IP Address Configuration

Integrated Web Page Configuration

Configuration with RSLogix 5000

User Configurable Device Parameters

Communication Fault/Idle Mode Parameter

I/O Sizes

Manifold and I/O Data Sizing Worksheet

Discrete I/O Side

Appendix

Factory Default Settings

Troubleshooting

Glossary of Terms

Technical Support

G3 Series EtherNet/IP