AMAZONASSEMBLY AND OPERATING INSTRUCTIONSPlace the nutrient tank in position ensuringthat it is level. Fill with water to the maximumlevel indicator. Place the chamber in positionwith the lowest drain point at the farthest endfrom the tank access.The Amazon delivery assembly will be packedflat. Turn the side arms at the blue elbow jointsso the sprinklers point up. Turn the centre barso the pump connector points down. Thearrows on the sprinklers should also bepointing straight up.Fit the strainer and foam filter to the pumpinlet. Make sure the pump outlet is at 90degrees to the main body of the pump. Movethe foot and sucker to the bottom of the pumpso the pump outlet is upright.Place the delivery assembly in position withthe side arms resting on the raised grooves inthe chamber base and the pump connectorthrough the hole in the nutrient tank.Fit the pump outlet to the connector on thedelivery assembly. It is a tight fit and mayrequire a little force. Put the pump intoposition securing to the bottom of the tankwith the rubber sucker.Place the lid in position (the picture shows the16 space option). Then plug the pump in totest, looking through several holes to ensurethat all 4 sprinklers are functioning correctly.Put the correx tank cover in place to excludelight from the nutrient solution.Carefully place your young plants in the holes(they should already be in net pots). If theyhave dangling roots (i.e. have been raisedin an aeroponic propagator) turn them whileinserting, this will guide the roots throughwithout damaging them.Add a fully balanced hydroponic nutrientaccording to the nutrient label instructions orgrowing schedule. Turn on the pump and topup your nutrient tank every few days.1 2 3 45 6 7 8