OHIOSTEEL 1084C Manual
  |
Manufactured underU.S. Patent No. 5,645,394WARNINGSThe loading ramp surfaces are sharp. Always wear proper clothing and use care when handling the loading• ramps. (Gloves are strongly recommended).Read and understand all safety and operating instructions before using the loading ramp. Never allow• anyone unfamiliar with these instructions to use the loading ramps.Read and understand all safety and operating instructions provided by the manufacturer of the equipment• the loading ramp will be used with.Extreme caution should always be used while loading and unloading your equipment.• Do not exceed the rated capacity of the loading ramp.• Do not exceed the rated capacity of the loading surface (i.e. tailgate). If unknown, contact the manufacturer• to find the maximum load capacity.Never stand in the path of equipment being loaded, and keep all bystanders and children away from• loading ramps.This ramp must be only used for loading and unloading to and from a level and stable surface.• Use caution when using ramp in icy or wet conditions. The ramp surface may become slippery.• Do not use this loading ramp to load live animals.• Do not use loading ramps as a bridge, scaffolding, or any other use for which it is not intended or designed.• If ramp is bowing while loading or unloading your equipment, which indicates an overload condition,• remove the equipment immediately.Do not attempt to load or unload any power equipment with its motor running.• Failure to follow these warnings may result in property damage and/or serious bodily injury.•SAFETYBe sure to read and follow all safety instructions and warnings. Failure to follow these instructions may• result in damage to the product and/or serious personal injury.Danger of serious personal injury exists. Serious personal injury can occur when using a loading ramp.• Never attempt to ride any vehicle up or down the loading ramp.• Look for a wall or a depression to reduce the loading angle, the lower the ramp angle the easier the loading• of the vehicle will be.Park the vehicle on flat, firm, grassy terrain.• Set the emergency brake and chock the tires of the loading vehicle to prevent any movement while loading• and unloading the equipment.Center loading ramp on the loading surface with support bars on top of the loading surface.• Make sure ramps are aligned at the proper distance apart so that the tires of the equipment being loaded• are centered on the ramp.To prevent kick back, always attach cam buckle straps between the bumper of the truck and the center of• loading ramp, pulling strap tight.Roll or winch equipment up or down the ramp.• Before each use, always check for any worn, loose, or damaged parts on the loading ramp. If any damage• is present, DO NOT USE THE RAMP.Periodically check the fasteners to make sure they are still tight and in place.• Keep ramp surface clean by occasionally cleaning with water and any mild detergent.• Do not add to or try to modify the loading ramp in any way. Any modifications will void any warranties as• well as affect the structural integrity of the ramp itself.OPERATIONWe suggest that you drill 7/16" diameter holes through the support bars (3) into the tail gate or truck bedso that the pins can be inserted as a safety device in holding ramps in place. To prevent kick back of theloading ramp, always attach cam buckle straps to bumper of truck and center of ramp pulling strap tight.Align individual ramps to correctly correspond to your wheel track. Always remove key, turn fuel off, andset parking brake after loading vehicle.STEEL FOLDING LOADING RAMPModel 1084C600lbs distributed weight capacity - single.• 1200lbs distributed weight capacity - double.• Compact storage.• One person loading.• |
Related manuals for OHIOSTEEL 1084C
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine