QuickSetup321 Check ContentsRemove the Protective SheetTilt up the image drum and lift it out. Do nottouch image drum’s green surface.Install the Paper Feed TrayBefore you can use your printer:q Steps 1 to 5 - Setup your printer.q Step 6 - Install the correct Interface cable for your system—USB or Parallel.q Step 7 - Determine your computer’s Operating System—Windows® 95, 98, 2000, NT ® 4.0 orMacintosh ® (OS 8.1 or higher), then install the correct printer software for your computer’sOperating System and Interface.q See the on-line User’s Guide for more information about your printer.Press down firmly until drum snaps into place.Ê PrinterË Paper Feed TrayÌ TonerÍ Power CordÎ CDÏ Light-Shield Bag (to protect imagedrum from light when it is removedfrom printer)Ð Quick Setup Instructions! Interface cable is not included. Forinformation on cable requirements, see“Supplies” in the on-line User’s Guide.Pull out sheet Ê, and remove tape Ë.If transparent film is attached, removefilm with sheet.58341901Lift the cover.Replace the image drum, tilting it downto slide under the guides Ê.ÊÊÊËPress to lock tray in place.Align tabs on bottom of paper trayinto slots on back of printer.Swing tray up and align tabsand slots at top.©2000 Oki Data Americas, Inc.ÊËÌÍÎÏÐAll manuals and user guides at all-guides.comall-guides.com