Before attempting any work involving mains water supply lines, ensure the water supply is shut off.Stop valves (preferably with filters) must be used when installing your Oliveri mixer to allow isolation. (notsupplied with mixer). Failure to do so where required will void warranty.This mixer tap is already pre-assembled and tested. Do not disassemble, as this may void the warranty.This mixer tap must be installed in accordance with these instructions.MAX OPERATING PRESSURE:..............................................................5 bar (500kPa)RECOMMENDED OPERATION PRESSURE:..........................................1.5-5 bar (150-500kPa)MAX HOT WATER TEMPERATURE:.....................................................65°CRECOMMENDED HOT WATER TEMPERATURE:..................................50°CPrague Basin mixerWhere water pressure exceeds 500kPa, a pressure reducing device is required to be installed. Note thatwater pressure overnight can reach 150% of the daytime pressure.CARE & MAINTENANCEClean with a soft cloth and warm soapy water as necessary - rinse and dry after cleaning. Under No Circumstancesshould abrasive or acid based cleaning products be usedWARRANTYThis mixer tap is warranted to be free from manufacturing defects for a period of 15 Years15 years for cartridge10 years for body, 5 years for seals, tails, fittings and aerators and 1 year for finish and labour, when used in adomestic situation.This warranty does not cover against normal wear and will be voided if the product is misused ornot installed in accordance with these instructions. Note: Fitting spout-attached devices, including waterfilters, to this mixer will void warranty.Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You areentitled to a replacement or refund for a major failure and for compensation for any other reasonablyforeseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail tobe of acceptable quality and the failure does not amount to a major failure.SERVICEIf the problem represents a danger, or damage to property may occur, immediately shut off the watersupply. If the mixer tap requires servicing, please contact your plumber (preferably the one who installedit). Most problems occur due to contaminated supply lines or water pressure exceeding 500KPa.Unscrew and clean the spout aerator periodically - especially if you notice a drop in water pressure.If the Plumber is satisfied that the problem is not due to poor installation, contact T2 Services Pty Ltd forassistance on:If a warranty service agent finds that the mixer tap is not at fault, T2 Services Pty Ltd reserves the right topass on any callout fee to the householder.THIS MIXER TAP MUST BE INSTALLED BY A LICENSED PLUMBER INACCORDANCE WITH LOCAL REGULATIONSThis Oliveri tap is manufactured to standard AS/NZS 3718.Note: Ceramic Cartidges - Warranty claims will not be honoured where the ceramic cartridge hasmalfunctioned due to the presence in the water supply of;- Copper tube pieces, sand, dirt or stones- Thread tape- Other objects not normally present in potable water supplies.- Do not remove the cartridge from the body as it has been pressure tested and tightened to aspecific torque.Issue Date 15/02/2019 Revision Number: V1.0Note: Installation of aerators containing flow regulators.Upon re-installation, the aerator should be tightened with an aerator key to prevent removal by hand.In the event this product is rendered obsolete and a replacement product is required, Oliveri Solutions Pty Ltdreserves the right to supply a product of equal substitution at their discretion.Ph: (07) 55960738Fax: (07) 55273353Email: oliveri@t2services.com.auhttps: //oliveri.com.au/service-and-warranty