PAC PAC-200 Installation Instructions Manual

Contents

installation instructions

PAC PAC-200 Installation Instructions Manual Manual pdf 1 page image

The relay will handle 200 amperes on a continuous basis at 12 VDC and 300 Amperes in rush peak or surge.Mount the relay between batteries as an isolator or in the main power lead servicing the mobile audio system,amplifiers, light bars or any other equipment requiring on/off control.INSTALLATION INSTRUCTIONS:The two small terminals are for switching the relay on and off. Either one of the small terminals should beconnected to chassis ground or other ground location and the other terminal to switching power output. Switchingpower must be between 10 and 16 VDC. The relay coil draws less than 1amp when switched on.Battery or main power leads use the two large terminals. Either one may be incoming power. Fuse power leads asclose to battery or batteries as possible.MODEL PAC-200MOBILE AUDIO RELAY AND BATTERY ISOLATOR200 Amp Continuous Power HandlingPacific Accessory Corporation - 1502 S. Santa Fe Street, Santa Ana, CA 92705www.go2pac.com Voice: 714-835-3133 Fax: 714- 835-3233 techsupport@go2pac.com_ +Battery_ +BatteryFU SEFU SEPAC-200Alternator+Accessory

/ 1

Related manuals for PAC PAC-200