PAC RPK4-CH4102 Manual

PAC RPK4-CH4102 Manual Manual pdf 1 page image

Complete Radio Replacement Kit withIntegrated Climate Control Retention for Select2014–2020 Dodge DurangoRPK4-CH4102© 2020 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.PAC-audio.comPacific Accessory CorporationPage 1Rev: v.1Date: 011021®Introduction and FeaturesThe RPK4-CH4102 is a complete radio replacement kit with integrated climate control retention for the 2014-2020Dodge Durango. All modules and cables are included to retain important features of the factory system including:steering wheel-mounted radio controls, factory reverse camera, and AM/FM reception.A secondary 5.2” LCD screen is added for additional vehicle features and controls including: vehicle performancegauges and information, climate controls, vehicle settings, factory amplifier control, and forced camera activation.Simplified installation and setup menus allow direct programming of camera triggers, steering wheel controls, andother settings of the kit and RP4.2-CH4102 interface. Features provided by the LCD screen will vary based on thevehicle features. See Important Notes (next section) for additional information.Four hard buttons added to the radio dash bezel (below the 5.2” LCD screen) allow the user to set presets to controlfunctions including: specific climate controls, forced camera activation, and LCD screen controls. Options for hardbuttons will vary based on vehicle features and which cameras are installed.Button inserts and seven button openings on the radio dash bezel allow for retention of functions that wouldtypically be lost when replacing the factory radio.Some advanced features require additional accessories (sold separately).Important Notes1. Does Not Retain:Cluster Display Features• Compass• Clock• Phone pop-ups• Navigation pop-upsFactory Amplifier Features• Speed Controlled VolumeUconnect Features• Uconnect Access Remote Start / Lock / Unlock• SOS / Assist• Vehicle Location Service• WiFi-HotspotSiriusXM Guardian ServicesRear Seat Entertainment (RSE)2. In vehicles equipped with parking sensors, you must use the included external speaker in order to continue hearingparking sensor chimes. If the vehicle has a factory amplified system and parking sensors, the speaker is not necessaryunless the factory amplifier is no longer being used. In cases where the factory amplifier and aftermarket amplifier arebeing used (for example, using an aftermarket amplifier for the front speakers and using the factory amplifier for the rearspeakers), the RPK4-CH4102 allows the chime output to the external speaker to be set to the channels that are beingdriven off of the aftermarket amplifier.3. If you are adding additional cameras, PAC part number RPA-16P5V (sold separately) must be used to connectup to 5 total cameras.4. It is very important that the vehicle’s accessory buttons be programmed and tested right away. If they do notoperate, it is likely because the incorrect CAN wire connections are being used.In 2018+ vehicles, the CAN connections must be made at the vehicle’s star connector (see page 10 for details). Failureto do so will cause the vehicle’s accessory buttons to not operate and may cause the vehicle’s battery to drain.We recommend reading this manual thoroughly to familiarize yourself with the entire processprior to beginning the installation.5. In newer (2018+) vehicles, the factory amplifier may not work or the audio level will be low until the ignition iscycled. Make sure the aftermarket radio’s volume level is turned down prior to cycling the ignition to preventexcess volume after the ignition cycle!6. Only in some 2014 Durangos: All vehicle settings options will be listed in the vehicle settings menu, including vehiclesettings that are not available for your vehicle. The only settings options that can be changed and saved, are optionsthat were available through the factory radio.Vehicle Accessories Buttons: