Padimount A7 Installation Instructions Manual
Contents |
Introduction:Your Padimount in-wall tablet mount wasdesigned to securely and elegantly mountyour tablet to the wall. It is thin enough tomount over a stud in drywall as thin as 1/2”.It comes with either a fingerprint resistantstainless steel, or a paintable white outerframe. The kit includes a USB over CAT5Epower extender, as well as all necessarymounting hardware and accessories.Contents:(1) Assembled Bracket / Frame(1) Retaining Ring with NeodymiumMagnets(1) Decorative Faceplate(1) USB (male) to RJ-45 (female) ChargingAdapter(1) USB (female) to RJ-45 (female)Charging Adapter(1 set) P-Clamps with Screws(1 set) Security Screws(1 set) Mounting Screws(1) Instruction Manual(1) Cutout Template(1) 2.5mm Allen KeyPlacement*: Determine if you will bemounting your tablet horizontally orvertically. Using the faceplate as a guide,locate the position on the wall where themount will be installed. Because of theshallow depth of the Padimount in-wallbracket, it is not necessary to limitplacement only to areas between studs.The in wall bracket is designed for use inlocations where 1/2” or 5/8” drywall hasbeen installed. In locations where otherbuilding materials have been used it may benecessary to use the included mountingscrews to install the bracket.Measure and mark the center point of thelocation you have chosen.*This step will have already been done if arough-in ring has been installed.Cutting the Opening*: Using a level,center and place the included cutouttemplate over the center point, making sureto maintain the correct orientation(horizontal or vertical) of the tablet. Mark andcut the opening using the appropriate tool,taking care not to damage any wiring,plumbing or ductwork inside the wall.Installation InstructionsIN-WALL BRACKET PLACEMENTApprox. CenterIWB-A10Cutout TemplateCUTOUT TEMPLATECut Around Tracingwith Drywall SawTrace Around TemplateCenter Over Mark |
manualsdatabase
Your AI-powered manual search engine