Panasonic BB-HCM547 Important Information Manual

Also see for BB-HCM527: Comparison chart Specifications Installation guide Setup guide Important information

Contents

Panasonic BB-HCM547 Important Information Manual Manual pdf 1 page image

Important InformationNetwork Camera (PoE Ready)Model No. BB-HCM527BB-HCM547Indoor Use OnlyOutdoor Ready© 2008 Panasonic Communications Co., Ltd. All Rights Reserved.PQQX16398ZA KK0608CM0How to Use the DocumentationThis manual is written for both the BB-HCM527 (Indoor Use Only) and theBB-HCM547(Outdoor Ready). Available features and operations varyslightly depending on the model. You can confirm the model no. of yourcamera by checking the model no. printed on the front of the camera.Model number suffix “A” is omitted from the following model numbersshown in this document, unless necessary. BB-HCM527A, BB-HCM547AAll documentation can be found on the included CD-ROM.• Important Information (PDF format; printed version also included)This document. Provides general information and safety instructions forusing the camera.• Installation Guide (PDF format; printed version also included)For BB-HCM527: Describes how to physically connect the camera tothe power supply and network, as well how to mount or place thecamera for regular use.For BB-HCM547: Describes how to connect the camera to the powersupply and network physically.• Mounting Guide (PDF format; printed version also included)For BB-HCM547: Describes how to mount or place the camera forregular use.• Setup Guide (PDF format; printed version also included)Describes how to set up the camera so that it can be accessed using aPC.• Operating Instructions (HTML format)Explains how to operate, program, and maintain the camera.• Troubleshooting Guide (HTML format)Provides solutions for problems you may have when using the camera.• Stand-alone SD Memory Card Recording Guide (PDF format; printedversion also included)Describes how to record images to an SD memory card without using aPC.Abbreviations• The Network Camera is referred to as “the camera” in this document.• The Setup CD-ROM is referred to as “the CD-ROM” in this document.• The term “SD memory card” is used in this document to refer to SDmemory cards and SDHC memory cards.IMPORTANT SAFETY INSTRUCTIONSWhen using this unit, basic safety precautions should always be followedto reduce the risk of fire, electric shock, or personal injury.Note:• References to the AC adaptor and the AC cord apply when using theoptional BB-HCA3A AC Adaptor.1. Read and understand all instructions.2. Keep these instructions.3. Heed all warnings.4. Follow all instructions.5. Attach the Safety Wire to the camera to prevent it from dropping.6. After taking away the sand or the dust on the lens cover, wipe the lenscover with a dry cloth.7. Do not block any ventilation openings. Install in accordance withinstructions.8. Do not install near any heat sources such as radiators, heat registers,stoves, or other devices (including amplifiers) that produce heat.9. Protect the AC adaptor cord and the AC cord from being walked on orpinched particularly at plugs, convenience receptacles, and the pointwhere they exit from the unit.10. The AC adaptor is used as the main disconnect device. Ensure thatthe AC outlet is installed near the product and is easily accessible.11. Only use attachments/accessories such as stand specified by themanufacturer.12. Do not touch the unit, the LAN cable, the AC adaptor, the AC adaptorcord, or the AC cord during lightning storms.13. Unplug the unit from power supply when unused for long periods oftime.14. Refer all servicing to qualified service personnel. Servicing is requiredwhen the unit has been damaged in any way, such as when the ACadaptor, the AC adaptor cord, or the AC cord is damaged, the unitdoes not operate normally, or has been dropped.15. Prolonged exposure to direct sunlight or halogen light may damagethe image sensor.16. For BB-HCM527: The camera is intended for indoor use only.For BB-HCM547: The camera features a splash-resistant body, but itis not waterproof.17. Keep the SD memory card (customer-provided) out of reach ofchildren to prevent swallowing.18. Unplug this unit from power supply if it emits smoke, an abnormalsmell or makes unusual noise. These conditions can cause fire orelectric shock. Confirm that smoke has stopped and contact anauthorized service center.19. The AC adaptor, the AC adaptor cord, and the AC cord are not splashresistant, and are intended for indoor use only.20. When installing cables through the ground, do not connect cablesunder the ground. Install cables through a conduit to protect them fromwater.SAVE THESE INSTRUCTIONSFCC and Other InformationThis equipment has been tested and found to comply with the limits for a ClassB digital device, pursuant to Part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment offand on, the user is encouraged to try to correct the interference by one ormore of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that towhich the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.This device complies with Part 15 of the FCC Rules. Operation is subjectto the following two conditions:(1) This device may not cause harmful interference, and (2) this devicemust accept any interference received, including interference that maycause undesired operation.Environment:For BB-HCM527: Do not install the camera where the temperature is lessthan +0 °C (+32 °F) or greater than +40 °C (+104 °F). Allow 10 cm(4 inches) clearance around the unit for proper ventilation. Avoid excessivesmoke, dust, mechanical vibration, shock, or direct sunlight.For BB-HCM547: Do not install the camera where the temperature is lessthan -20 °C (-4 °F) or greater than +50 °C (+122 °F). Allow 10 cm (4 inches)clearance around the unit for proper ventilation. Avoid excessive smoke,dust, mechanical vibration, shock, or direct sunlight.Routine care:Wipe the unit with a soft cloth. Do not use benzine, thinner, or any abrasivepowder.When you leave the unit unused for a long period of time, disconnect theLAN cable (when using PoE) from the camera, or disconnect the ACadaptor from the outlet (when using the AC adaptor).If you have any problems:Consult an authorized Panasonic Factory Service Center.CAUTION:Any changes or modifications not expressly approved by the party responsiblefor compliance could void the user’s authority to operate this device.No responsibility will be taken by our company with respect toconsequences resulting from the use, damage or both of thecamera.Please read this document before using the product, and save this document for futurereference.Panasonic Network Camera Website:http://panasonic.co.jp/pcc/products/en/netwkcam/regionlinks/index.html

/ 2

Related manuals for Panasonic BB-HCM527