Panasonic BL-C160 User Manual

Also see for BL-C140: Comparison chart Specifications Setup guide Installation guide Important information

Contents

Panasonic BL-C160 User Manual Manual pdf 1 page image

Important InformationNetwork CameraModel No. BL-C140BL-C160© Panasonic System Networks Co., Ltd. 2008PQQX16446XA KK0508CM2120 (CE)How to Use the DocumentationThis manual is written for both the BL-C140 and BL-C160. Availablefeatures and operations vary slightly depending on the model. You canconfirm the model no. of your camera by checking the model no. printed onthe front of the camera.Model number suffixes (“CE” and “E”) are omitted from the following modelnumbers shown in this document, unless necessary. BL-C140CE, BL-C140E, BL-C160CE, BL-C160E.All documentation can be found on the included CD-ROM.• Important Information (PDF format; printed version also included)This document. Provides general information and safety instructions forusing the camera.• Installation Guide (PDF format; printed version also included)Describes how to physically connect the camera to the power supplyand network, as well how to mount or place the camera for regular use.• Setup Guide (PDF format; printed version also included)Describes how to set up the camera so that it can be accessed using aPC.• Operating Instructions (HTML format)Explains how to operate, program, and maintain the camera.• Troubleshooting Guide (HTML format)Provides solutions for problems you may have when using the camera.Abbreviations• The Network Camera is referred to as “the camera” in this document.• The Setup CD-ROM is referred to as “the CD-ROM” in this document.IMPORTANT SAFETY INSTRUCTIONSWhen using this unit, basic safety precautions should always be followedto reduce the risk of fire, electric shock, or personal injury.1. Read and understand all instructions.2. Keep these instructions.3. Heed all warnings.4. Follow all instructions.5. Attach the Safety Wire to the camera to prevent it from dropping.6. After taking away the sand or the dust on the lens cover, wipe the lenscover with a dry cloth.7. Do not block any ventilation openings. Install in accordance withinstructions.8. Do not install near any heat sources such as radiators, heat registers,stoves, or other devices (including amplifiers) that produce heat.9. Protect the AC adaptor cord and the AC cord from being walked on orpinched particularly at plugs, convenience receptacles, and the pointwhere they exit from the unit.10. The AC adaptor is used as the main disconnect device. Ensure thatthe AC outlet is installed near the product and is easily accessible.11. Only use attachments/accessories such as stand specified by themanufacturer.12. Do not touch the unit, the LAN cable, the AC adaptor, the AC adaptorcord, or the AC cord during lightning storms.13. Unplug the unit from power supply when unused for long periods of time.14. Refer all servicing to qualified service personnel. Servicing is requiredwhen the unit has been damaged in any way, such as when the ACadaptor, the AC adaptor cord, or the AC cord is damaged, the unitdoes not operate normally, or has been dropped.15. Prolonged exposure to direct sunlight or halogen light may damagethe image sensor.16. Keep the sensor-range caps out of reach of children to prevent swallowing.17. Unplug this unit from power outlets if it emits smoke, an abnormalsmell or makes unusual noise. These conditions can cause fire orelectric shock. Confirm that smoke has stopped and contact anauthorized service center.18. The camera features a splash-resistant body, but it is not waterproof.19. The AC adaptor, the AC adaptor cord, the AC cord, and the powertransfer unit are not splash resistant, and are intended for indoor useonly.20. When connecting the cable, waterproof the cable using the includedright-angle joint, foam strip and self bonding tape.21. When installing cables through the ground, do not connect cablesunder the ground. Install cables through a conduit to protect them fromwater.22. For BL-C160CAUTION:The camera of this unit utilizes LED lights.Do not look directly at the LED lights for long periods of time, as thiscan cause weakened eyesight.SAVE THESE INSTRUCTIONSOther InformationEnvironment:Do not install the camera where the temperature is less than -20 °C orgreater than +50 °C. Allow 10 cm clearance around the unit for properventilation. Avoid excessive smoke, dust, mechanical vibration, shock, ordirect sunlight.Routine care:Wipe the unit with a soft cloth. Do not use benzine, thinner, or any abrasivepowder.When you leave the unit unused for a long period of time, disconnect theplug of the AC cord from the outlet.If you have any problems:Consult an authorized service center.CAUTION:Any changes or modifications not expressly approved by the party responsiblefor compliance could void the user's authority to operate this device.System RequirementsYour PC and network must meet the following technical specifications inorder for the camera to function properly.*1 What is IPv6?• IPv6 is short for “Internet Protocol Version 6”.• IPv6 was created to provide the additional IP addresses that will beneeded as the Internet continues to expand.• IPv6 is expected to gradually replace IPv4, with the 2 coexisting for anumber of years during a transition period.• Though most ISPs (Internet Service Providers) do not yet support IPv6,many local networks already use it. When your ISP supports IPv6, yourPanasonic Network Camera will be ready!Note:Refer to the Panasonic Network Camera website athttp://panasonic.net/pcc/support/netwkcam/for details about network environment.No responsibility will be taken by our company with respect toconsequences resulting from the use, damage or both of thecamera.Item RequirementOperating System For IPv4 ConnectionMicrosoft ® Windows Vista ® , Windows ® XP,Windows 2000For IPv6 Connection*1Microsoft Windows Vista,Windows XP Service Pack 1 or laterCPU 2.0 GHz Celeron ® or fasterDisplay 1024 x 768 resolution or higherProtocol For IPv4 ConnectionTCP/IP protocol (HTTP, TCP, UDP, IP, DNS, ARP, ICMP)For IPv6 ConnectionTCP/IP protocol (HTTP, TCP, UDP, IP, DNS, ICMPv6, NDP)Interface 10/100 Mbps network cardWeb Browser Internet Explorer ® 6.0 or later (not included)Additional Software(For Viewing Buff-ered MPEG-4Images)For Windows VistaWindows Media ® Player 11 or laterFor Windows XPWindows Media Player 9 or laterFor Windows 2000Windows Media Player 9Please read this document before using the product, and save this document for futurereference.Panasonic Network Camera Website:http://panasonic.net/pcc/ipcam/Outdoor Ready

/ 2

Related manuals for Panasonic BL-C140