How to install the monitor5U type (tilting type) 4U type (rack-mounted type)2 Separate the main controls from the BT-LH900 series monitor.(Refer to the instructions in the operation guide of the BT-LH900series.)1 Remove the eight blind screws from the BT-LH900 series.(Refer to the instructions in the operation guide of the BT-LH900series.)1 Remove the eight blind screws from the BT-LH900 series.(Refer to the instructions in the operation guide of the BT-LH900series.)2 Secure the main controls at bottom of the BT-LH900 seriesmonitor. (Refer to the instructions in the operation guide of theBT-LH900 series.)5 Use the four screws to secure the rear panel and plug the cableof the main controls into the connector on the monitor. (Refer tothe instructions in the operation guide of the BT-LH900 series.)4 Use the four screws to secure the rear panel.3 Secure the now separated main controls to the adapter.1 Pass the cable of the main controls through the holeprovided.2 Secure the main controls using the screws.4 1 Remove the four screws and remove the rear panel.2 Secure the monitor to the adapter using the four screwsprovided.3 1 Remove the four screws and remove the rear panel.2 Secure the monitor to the adapter using the four screwsprovided.Installation GuideRack mounting adapter for BT-LH900 seriesBT-MA900GThe BT-MA900G rack mounting adapter is designed to be mountedon the model BT-LH900 series, a liquid crystal video monitor used incommercial applications, and make it possible to install this monitor ina standard 19-type rack.By replacing the bottom panel of the BT-LH900 series with theaccessory panel provided with the adapter, this 5U type (initial status)of video monitor which can be tilted upward or downward can beturned into a 4U type of rack-mounted stationary type of monitor.Before using the rack mounting adapter to install the monitor, turn offits power.How to replace the monitor’s bottom panel1 While referring to the figure on the right, remove the total of 12screws.2 Loosen the four screws on the top panel, and remove the bottompanel.3 Replace the monitor’s bottom panel with the accessory panel, anduse the screws removed in step 1 to secure it.4 Tighten up the screws which were loosened in step 2.132, 4Ensure that a temperature from 0 to 40 degrees Celsius ismaintained inside the rack.Accessory parts:8 screws for installing monitorBottom panel for 4U type (rack-mounted type)12122VQT0G64-2SE0903AT2031 -FJ @Printed in JapanENGLISH