Mounting boardCeiling boardMounting boardCeiling board2 Setting up the Mounting board.For suspended ceilings(1) Prepare a Mounting board long enough tospan the distance between the C-beams,and cut a φ60 mm {2-3/8”} hole in it thatmatches the hole in the ceiling.(2) Use the template (provided) to cut four φ6mm {1/4”} holes (in four positions) in themounting board.For structurally strong ceilingsPrepare the mounting board by cutting a φ60mm {2-3/8”} hole in it.FEATURESCeiling Mount BracketInstructionsModel Nos. WV-Q117/WV-Q117EAM0205-0 3TR003442AAA Printed in JapanC beamM beam 60 mm in diameter{2-3/8”}Ceiling1 Decide where to install the camera and opena φ60 mm {2-3/8”} hole in the ceiling.INSTALLATION3 Attach the Ceiling Mount Ring (provided) tothe Mounting board Screws are not provided.Align it with the position the camera will beinstalled.7For suspendedceilings7For structurallystrong ceilingsCeiling Mount Ring(provided)Ceiling Mount Ring(provided)M4 Screws(not provided)Wood screws(not provided)The Ceiling Mount Bracket WV-Q117 is used tomount the Combination Camera WV-CS950 orWV-CS954 on a ceiling.Before attempting to connect or install this product,please read these instructions carefully andsave this manual for future use.• Fasten the bracket to a ceiling strong enoughto support the camera weight (approx. 2.9 kg{6.38 lbs}).• Wipe the bracket regularly using a soft anddry cloth, or a cloth moistened with a watersolution of an ordinary kitchen detergent.• Do not use chemicals for cleaning the enclo-sure as it may damage the surface.• All the necessary steps required for installingthis product must be taken by a qualified ser-vice person or system installer.PRECAUTIONS• Be sure to use the aniti-fall wire.• Do not use this branket with any equipmentother than the WV-CS950 and the WV-CS954.• Follow all applicable local and national elec-trical, fire and safety codes when installingthe camera with this ceiling mount bracket.The model numbers in this Operating Instruc-tions are shown without suffix.15°MountingScrewRotateRemove the CameraMounting Base bypulling up.4 Installing the Mounting board.For suspended ceilingsAlign it with the hole in the ceiling and lay itacross the two C-beams.For structurally strong ceilingsAlign it with the hole in the ceiling and attachit.5 Remove the Mounting Screw (M3, provided),pull up the Camera Mounting Base off thecamera, and turn the camera counterclock-wise.Lock LugFixing ScrewsL-type Base Lug (provided)Lock LugLock LugFixing Screws6 Remove the two Lock Lug Fixing Screws andreplace the Lock Lug with L-type.Retighten the two Lock Lug Fixing Screws(refer to the right figure).UT+O//5?C.3,0,0/.825ɚĘȸ/