Caution: Before attempting to connect or operate this product, please read these instructionscarefully.Notice: This product is not suitable for use in locations where children are likely to be present. Do not install this product in locations where ordinary persons can easily reach. For information about screws and other parts required for installation, refer to thecorresponding section of this document.Standard accessoriesOperating Instructions (this document).... 1 pc.Camera fixing screws............................... 2 pcs.(M4 × 8 mm {5/16 inches})Screw caps................................................ 2 pcs.Fixing screws............................................ 5 pcs.(M4 × 8 mm {5/16 inches}) (of them, 1 for spare)Precautions for installation In order to prevent injury, the product must be securely mounted to a Gangbox/Junction box according to installation guide. Make sure to remove this product if it will no longer be used.Note: When installing outside, installation work shall be such that there is no exposure to waterinto the architecture through the Gangbox/Junction box or conduits having been joined. InstallationStep 1 Compatible Gangbox/Junction boxOperating InstructionsIncluded Installation InstructionsGangbox AdapterWV-QAT502-WModel No. WV-QAT502-G Before attempting to connect or install this product, please read these instructions carefullyand save this manual for future use. Be sure to read “Precautions” in this document before use. The external appearance and other parts shown in this manual may differ from the actualproduct within the scope that will not interfere with normal use due to improvement of theproduct.Panasonic i-PRO Sensing Solutions Co., Ltd. assumes no responsibility for injuries orproperty damage resulting from failures arising out of improper installation oroperation inconsistent with this documentation.PrefaceThis product is used when installing a compact dome type camera using a Gangbox/Junctionbox.For the latest information about the supported cameras, refer to our support website(https://security.panasonic.com/training_support/support/info/).SpecificationsAmbient operating temperature: –50 °C to +60 °C {–58 °F to +140 °F}Dimensions: ø162 mm × 6.2 mm (H){ø6-3/8 inches × 1/4 inches (H)}Mass: Approx. 144 g {0.32 lbs}Finish: Aluminum die cast WV-QAT502-W : i-PRO whiteWV-QAT502-G : Light grayPrecautions Refer installation work to the dealer.Installation work requires technique and experience. Failure to observe this may cause fire,electric shock, injury, or damage to the product.Be sure to consult the dealer. Install the product securely on a Gangbox/Junction box in accordance with theinstallation instructions.Failure to observe this may cause injury or accidents. Do not use this product except with suitable cameras.Failure to observe this may cause a drop resulting in injury or accidents. Do not install this product on a place that is greatly influenced by wind.Installation on a place where the wind speed is 60 m/s {approx. 134 mph} or more may cause afall of the product resulting in injury or accidents. The screws and bolts must be tightened to the specified torque.Failure to observe this may cause a drop resulting in injury or accidents.When using this product, also read the “Precautions” described in the operatinginstructions for the camera to be attached.© Panasonic i-PRO Sensing Solutions Co., Ltd. 2021Fs0321-0Printed in ChinaFor U.S. and Canada:Panasonic i-PRO Sensing SolutionsCorporation of America800 Gessner Rd, Suite 700 Houston, TX 77024https://www.security.us.panasonic.com/Panasonic Canada Inc.5770 Ambler Drive, Mississauga, Ontario, L4W 2T3 Canada1-877-495-0580https://www.panasonic.com/ca/For Europe and other countries:Panasonic Corporationhttp://www.panasonic.comPanasonic i-PRO Sensing Solutions Co., Ltd.Fukuoka, JapanAuthorised Representative in EU:Panasonic Testing CentrePanasonic Marketing Europe GmbHWinsbergring 15, 22525 Hamburg, Germany46 mm {1-13/16 inches}83.5 mm{3-9/32 inches}63 mm {2-15/32 inches}63 mm{2-15/32 inches}
