Operating InstructionsIncluded Installation InstructionsRJ45 Ethernet Cable For professional use only.Model No. WV-QCA500A (1 pc.)WV-QCA500APK (10 pcs.) Before attempting to connect or install this product, please read these instructions carefullyand save this manual for future use. The external appearance and other parts shown in this manual may differ from the actualproduct within the scope that will not interfere with normal use due to improvement of theproduct. Also read the Operating Instructions for the camera you are using.Panasonic i-PRO Sensing Solutions Co., Ltd. assumes no responsibility for injuries orproperty damage resulting from failures arising out of improper installation oroperation inconsistent with this documentation.© Panasonic i-PRO Sensing Solutions Co., Ltd. 2021Fs0421-0Printed in ChinaFor U.S. and Canada:Panasonic i-PRO Sensing SolutionsCorporation of America8550 Fallbrook Drive, Suite 200 Houston, Texas 77064https://i-pro.com/Panasonic Canada Inc.5770 Ambler Drive, Mississauga, Ontario, L4W 2T3 Canada1-877-495-0580https://www.panasonic.com/ca/For Europe and other countries:Panasonic Corporationhttp://www.panasonic.comPanasonic i-PRO Sensing Solutions Co., Ltd.Fukuoka, JapanAuthorised Representative in EU:Panasonic Testing CentrePanasonic Marketing Europe GmbHWinsbergring 15, 22525 Hamburg, GermanyPrefaceThis product is an Ethernet extension cable with a waterproofing grommet. By using an RJ45waterproof jack to convert the RJ45 network connector on an outdoor camera, it is possible toeasily replace a past model that uses a waterproof connector.For the latest information about the supported cameras, refer to our support website(https://security.panasonic.com/training_support/support/info/).SpecificationsPower source*1: PoE (IEEE802.3af compliant)Ambient operating temperature: –40 °C to +60 °C {–40 °F to +140 °F}Ambient operating humidity: 10 % to 100 % (no condensation)Storage temperature: –30 °C to +60 °C {–22 °F to +140 °F}Storage humidity: 10 % to 95 % (no condensation)Network*1: 10BASE-T / 100BASE-TX / RJ45 connectorMass: Approx. 35 g {0.08 lbs}*1 The specifications of the network camera body apply.Precaution Do not attempt to disassemble or modify this product.Failure to observe this may cause fire or electric shock. Consult the dealer for the repair orinspections. Refer installation work to the dealer.Installation work requires technique and experience. Failure to observe this may cause fire,electric shock, injury, or damage to the product. Be sure to consult the dealer. Turn the power off when do wiring of this product.Failure to observe this may cause electric shock. In addition, short circuit or wrong wiring maycause fire. Correctly perform all wiring.Short circuits in the wiring or incorrect wiring may cause fire or electrical shock.