Pandigital KTC Quick Start Manual
Also see for KTC: User guide
  |
Quick Start Guide1. Place the KTC monitor facedown on a soft cloth withthe bottom edge of themonitor facing you alongthe edge of the flat surface.Tilt stand slightly to insertAttach the Countertop Stand®the two tabs on thestand assembly intothe slots on stand,and then lower standso it lays flat againstthe stand assembly.2. Use a Phillips headscrewdriver to insertthree small screwsfrom bottomand hand tighten.3. Turn the KTC uprightand remove theprotective plastic sheetfrom the front of themonitor.To mount on Wall orUnder CabinetUse the wall mount kit and‘Flat Panel TV Mounting’sInstallation and Assembly’instructions (separate doc).Plug in and Power On KTC1. Plug the power adapter into a wall outlet and theninto the power connector on the back of the KTC.Wireless Wi-Fi Setupfor Internet Access1Remove the back battery cover and insert two AAA batteries (included) into the remotecontrol, matching the (+) and (-) symbols.Install Batteries in Remote Control234Since you have not yet connected to theTV source, you may see these messagesthe first time you power ON the KTC.To clear, press the SOURCEbutton on the remote control,Use CH+ or CH- to highlightDPF, and then press ENTER.2. Press the POWER button on the remote control or the power buttonon the KTC located in the middle of the speaker bar on the bottom ofthe KTC screen.IMPORTANT:‘Proceed with Auto Scan’ or‘No Signal’ Messages1 Insert the wireless Wi-Fi USB Adapter into the USB host porton the left side of the KTC.Connect the Wireless Wi-Fi USB AdapterINPUT SOURCETVAVS-VideoComponentDPFHDMIPC231. With the HOME screen displayed, press SETUP.2. Use the arrows to highlight Network Setup, and then press ENTER.3. Use the arrows to highlight Search for Network, and then press ENTER.4. Select the desired wireless network, and then press ENTER.5. Enter your wireles network Password; use the arrows to navigate thevirtual keyboard and press ENTER to select highlighted characters.6. Select Done.7. When your MAC and IP addresses appear on the screen, setup iscomplete. Press EXIT until you return to the HOME screen.Set up Wireless Network on KTCEstablish accounts with Google PicasaTM and Windows Live FrameItVisit http://picasaweb.google.com to set up an account, create folders, and upload your photos.Visit http://frameit.live.com to set up an account, create folders, and assign desired RSS feed content.Connect to the Internet and Access Picasa and FrameIt1. With the HOME screen displayed, use the arrows to highlightINTERNET, and then press ENTER.2. Refer to the INTERNET section in the KTC User Guide for fullsetup instructions and usage for both Picasa and FrameIt.The wireless network to whichyou are connected should bedisplayed at the bottom of themenu options. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine