TM17915-A2-GK40-00 September 1997HotWire 7915 E1 SDSL Standalone Termination UnitErratumDocument Number 7915-A2-GK40-00September 1997The first HotWire 7915 E1 SDSL Standalone Termination Units have an invalid label on the back panel.The connector labeled DS1 is actually a 120-Ohm E1 interface. The correct labeling is shown below.DSL E1/2048 Kb/S48 VDC120 OHM97-15704G.703-Compatible (120-Ohm Interface) HotWire 7915 – Rear Panel   *7915–A2–GK40–00*

Paradyne HotWire 7915 Connection Manual

HotWire 7915

important safety instructions

about this guide

HotWire 7915 Models and Features

Typical Configurations

User Interface Types

Overview

Connecting to the Network and Application Equipment

Connecting Power to the Unit

Choosing an Interface Mode

Switching Between Terminal and Switchpack Modes

Accessing Configuration Options

Making Changes from the Terminal Interface

Making Changes in Switchpack Mode

Displaying Switchpack Definitions

Selecting V.35 or V.11 Signaling

What to Monitor

Board Status

Performance Statistics

Remote Unit Information

Front Panel LEDs

Detecting a Problem

Local Loopbacks

Remote Loopbacks

Starting and Ending Loopbacks

G.703-to-G.703 Configuration

G.703-to-V.35/V.11 Configuration

G.703-Compatible Units Configuration Worksheet

Terminal Connection Cable

SDSL Connection Cable Pin Assignments

DB25-to-V.35 Adapter Cable Pin Assignments

G.703-Compatible Units

V.35/V.11-Compatible Units