Paser PARKVIEW CF0006UNPS51 Installation Manual
         |
Release date: 24.07.18 rev 1.0 181 / 9DESCRIPTIONPARKVIEW is an electronic module easy to install, that allows you to integrate professionally aermarket parking sensors on the vehicles equipped withthe OEM radio.The device allows to display on the OEM radio the parking opera"on as it happens for the OEM parking sensors.VOLKSWAGENBEFORE STARTING INSTALLATION, PLEASE ENABLE THE PARKING SENSOR FUNCTION ON THE VEHICLEBY USING OFFICAL VW DISGNOSTIC DEVICE ODIS.CONNECTIONSThe harness supplied with PARKVIEW is split in 2 sec"ons, the first is composed by 4 wires to connect back the OEM radio of the vehicle.In the FAKRA plug it must to connect:YELLOW to the +12vdc posi"ve wireBLACK to the GND nega"ve wireGREEN to the CAN HWHITE to the CAN LThe diagram above suggests how to make the connec"ons, FAKRA plug is seen from wires exit side.Second sec"on of the harness is the 5 mt long extension that must to lay down "ll the boot where is located the parking sensors device.Once made the calibra"on connect the connector A in the connector of the parking sensors as above described.Please use the BUZZER of the parking sensors. To power the parking sensors please connect it to the reverse lamp.Once the connec"on are done the system is immediately ready to work, each "me the canbus line will wake up the LED of PARKVIEW will light GREEN toindicate the correct behaviour of the module. Then by inser"ng the reverse parking sensors will ac"vate, consequently PARKVIEW will ac"vate the visualizingon the OEM radio. With some radio MUTE is managed directly by the radio. By removing the back gear the visualizing will be interrupted.R 1 3 52 4R 1 3 52 4RCD 310By switching on the parking sensors, Parkview led will generate some red/green flashes confirming the right working.E3 10R-03 1158PARKVIEW CF0006UNPS51CANBUS MODULE TO VIZUALIZE PDC ON CAR DISPLAYCOBRA PS 0158INSTALLATION MANUAL45’Wires exit viewCAN HCAN L12 VDCGNDCAN HCAN L12 VDCGNDFakra 40 ways Fakra 52 ways Once the calibra"on has been performed,disconnect the BUZZER and connect connectorA: the system is now ready to operate.BUZ 4 3 2 1AAer making the connec"ons, connect theParking Sensor KIT BUZZER and the PARKVIEWwiring connector B and calibrate the Cobrasystem as usual.BUZ 4 3 2 1BA |
Related manuals for Paser PARKVIEW CF0006UNPS51
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine