Q'STRAINT QLK-150 Installation Instructions Manual
          |
INSTALLATION INSTRUCTIONSQ300M MINIREAD ALL INSTRUCTIONS PRIOR TO INSTALLATION• This is a comprehensive step-by-step instruction guide on how to install the Q300M Mini Wheelchair Bracket 41 Amp batteries only(wheelchair manufacture date February 2019).• Make sure to read, understand and follow all these instructions.• To address any questions contact the nearest Q’Straint office.• All deviations and alterations from these instructions MUST be reported to both your supervisor and Q’Straint .• For installation of the QLK Docking system, please refer to the separate Installation Instructions and the Use and Care Manual.IMPORTANT SAFEGUARDS AND WARNINGSSAVE THESE INSTRUCTIONS• All equipment and components MUST be installed and servicedby an experienced and trained technician.• The QLK-150 Wheelchair Docking System complies with allapplicable requirements of ADA, FMVSS, CMVSS, SAE J2249,CSA Z604, AS2942, ISO 10542-1 and ANSI/RESNA WC-4SECTION 18.• This System is a complete integrated system, do not alter ormodify it in any way and do not interchange or substitute anycomponents. Any deviation from these recommendations is theresponsibility of the installer.• The QLK-150 Docking System, bracket and its componentsMUST be regularly inspected, cleaned and maintained.• Do NOT attempt to repair, adjust, or modify any component(s) ofthe QLK-150 system or bracket without consulting a Q’Straint®representative.• The QLK-150 Wheelchair Docking System should not beoperated by anyone who does not have full comprehension ofhow the System works or if the System is not working properly.• The QLK-150 Wheelchair Docking System, bracket and allsystem components including floor and wall anchorages MUSTbe replaced after a vehicle collision• The QLK-150 Wheelchair Docking System MUST be installedwith a compliant occupant restraint system (shoulder and lapbelt).• Broken and worn components MUST be replaced.• All damages and defects MUST be reported to both yoursupervisor and Q’Straint®.• Only use Q’Straint® components with this system, includinghardware and wheelchair interface bracket unless otherwisestated.• Q’Straint wheelchair brackets and QLK docking station havebeen designed and tested as a system, for use with specificwheelchairs.• Q’Straint supplies all the components/hardware required toinstall the system so the configuration is the same as that testedand set out in the individual installation instructions.• Occasionally, wheelchairs may have additional componentsinstalled which are not detailed in our installation instructionsand which may need to be temporarily removed in order togain access to fixing holes or support frames to enable theattachment of the wheelchair bracket.• It is the responsibility of the installer to ensure that all suchwheelchair component(s) are put back in their original locationusing the original fixings or fixing of the same size and grade.• Each wheelchair should be test driven after fitment of thebracket, to ensure it is functioning correctly. |
Related manuals for Q'STRAINT Q300M MINI
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine