QOLSYS IQ Outdoor Plug-PG Installation Manual
IQ Outdoor Plug-PG Installation GuideSafety informationWARNING:• Only install and use this product in accordance with applicable electrical codes and regulationsin your region.• The device is suitable for outdoor and damp locations. However, you should not immerse thedevice in water.• Install the device above ground level at a minimum of 4.7 ft or 1.4 m with the outlets facingdownwards when outdoors.• The total current limit of the device is 15 Amps. To prevent damage, do not exceed the 15 Ampslimit. A direct short on the output may cause the device to malfunction.• Do not attempt to disassemble or repair the product yourself. Doing so may result in electricshock and will void the limited warranty. If you require assistance, contact our after-salesservices.• IP65 protection can only be achieved when the rubber cover blocks the outlets.• Ensure that the plugs are completely inserted into the socket without any metal prongsexposed.• Ensure that each socket is covered when not in use. To properly use the rubber cover, turn theIQ Outdoor Plug-PG with the sockets facing up and press firmly on the rubber covers.• Make sure to use this product together with a 15A circuit breaker.• Figure 1: Do not plug smart devices into each otherD-308966*D-308966*D-308966 Rev 00D-308966 IQ Outdoor Plug-PG Install Guide |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine