QUATROS QS19134 Owner's Manual
     |
aaPW TECHSAM Woch Sp. J. tel. 81 444-63-73ul. Warszawska 131 tel. 81 443-08-1220-824 Lublin fax 81 458-38-19www.quatros.eu e-mail: techsam@quatros.plIMPORTER:OWNER’SMANUALHYDRAULIC TROLLEY JACK LOW PROFILE, DUAL PUMP 3TQS19134DESCRIPTIONHydraulic Trolley Jack Low Profile Dual Pump 3T QS19134: Capacity: 3T | Min. height: 75mm | Max. height: 500mm | Weight: 33kgSAFETY INSTRUCTIONSWARNING- This jack is a lifting device, designed ONLY for lifting part of the total vehicle (i.e one wheel). Do not move or dolly thevehicle while itis on the jack. Never use lift device to raise any others load.- Position this jack to ONLY lift on the areas of the vehicle as specified by the vehicle manufacturer.- After lifting the vehicle, ALWAYS support the load with appropriately rated vehicle support stands BEFORE working on thevehicle.- Do not overload this jack beyond its rated capacity. Overloading can cause damage to or failure of the jack.- This jack is designed ONLY for use on hard level surfaces capable of sustaining the load. Use on other than hard levelsurfaces can result in jack instability and possible loss of load.- Center load on jack saddle BEFORE lifting vehicle. Off-center loads and loads lifted when the jack is not level can cause lossof load or damage to the jack.- Study, understand and follow all instructions in this manual BEFORE operating the jack.- Failure to heed this warning may result in loss of load, damage to the jack and/or jack failure resulting in personal injury orproperty damage.OPERATIONWARNING! Ensure that you read, understand and apply the safety instructions.ASSEMBLING HANDLEInsert handle piece (part no. 19) into middle handle piece (part no. 18) making sure holesline up for retaining clips. With the jack sitting on its wheels on a flat surface, slideassembled handle into handle base (part no. 20), rotate until the square-shaped hole slipsover shaft in handle base. Loosen ½ turn handle should rotate easily.At the rear of jack a large metal clip holds handle base flat against the jack. While keepinghandle pushed down in compressed position, carefully remove clip by pulling out. Releasepressure on handle base and discard.PREPARING WORK AREABefore using jack to lift vehicle it is important to prepare work area properly. Follow this procedure each time the jack is used tohelp prevent property damage and or serious injury.1. Thoroughly inspect jack for damage or wear before each use. Briefly test operation of unloaded jack before using to lift. Ifjack is damaged or is malfunctioning DO NOT LIFT ANY LOAD until the problem is corrected.2. The Vehicle manufacturer’s owner’s manual should be consulted prior to the lifting of the vehicle. It will advise safetyprecautions, jacking procedure, vehicle weight, recommended jack type, and location of jack support areas on vehicle. Theworking load limit of the jack is 3000 kg. NEVER EXCEED WORKING LOAD LIMIT OF THE JACK. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine