2 Y E A R SG U A R A N T E EUnchangeable LEDScout WL Dark Grey92301Max.6x0.5W LED3000K±300K10000H3.7V1800mAhLI-IONRechargeablebatteryIIIINSTRUCTION MANUAL121 2 φ6mm30mm35 77 M4 Mappro.90°1.8-2.5m10.1cm14.3cm12.1cm75°13.5cm6AUTOST4x30mm48ST4x30mm6x 6x6X270IP44HOW TO DETERMINE WHERE TO MOUNT YOUR SOLAR PIR SENSOR LIGHTThe most important thing to remember for the operation of your SOLAR PIR SENSOR LIGHT is thatit works from the power contained in DIRECT SUNLIGHT. The more direct sunlight the solar cellreceives in a day, the longer the light will operate.Main Unit:The main unit contains 6*0.5W LED, motion sensor and battery (3.7V 1800mAh LI-IONRechargeable battery). When deciding where to mount this unit, keep in mind that the motionsensor that actives the light has a “field of vision” of min. 7 meters (in front of the light) and about90º (horizontal) at 25 environmental temperature.Solar Cell:The solar cell is the power source for the SOLAR PIR SENSOR LIGHT. It converts the sun’s energyinto electricity that charges the battery stored in main unit. This requires DIRECT SUNLIGHTfalling onto the face of solar cell for as long as possible over the course of day.CLEANINGIt is important that the solar panel is kept free of dirt and debris. A dirty solar panel will not allowthe battery to fully charge and this will shorten the life of battery and cause the light to malfunctionImportant: Please ensure that you charge the solar lights in maximum sunlight for aperiod of up to 3 days (for 1800mAh Li Battery) before switching on the lights, in order thatthe lights work on a full charge