Qik-Zepp QZ-60 Instructions Manual
  |
Qik-Zepp(1/2 wL end fed antenna)Please read the instructions! You'll be glad you did!www.qikzepp.com Tel 603-651-0427What's in the box?Qty Part Qty Part1 60 Meter QZ-60 Matcher 1 Drip Dam1 60M Antenna Wire 95'(un-tuned) 1 QZ-60 Manual1 End InsulatorSafety first!* Do not install over or around AC power lines or feeders, you could be killed or injured!* Do not touch or allow others to touch the antenna while transmitting over 1 KV can be present!* RF Exposure, follow the FCC OET Bulletin 65 and Amateur Radio Supplement B to OETBulletin 65 guidelines. Best practice as usual, use the least amount of power needed.Tips & Advice--This is a Single Band Antenna, DO NOT try to force it onto other bands!--Do NOT USE conductive guy lines to support it, and never tie directly to trees without using a pulley system!--Deploy away from other antennas or metal if possible.Putting it together:1. In the shipping box you will find the matching unit for 60M with a ~95 ft radiator(un-tuned) permanently attached.Under the U.S. FCC regulations for 60M you can only transmit up to 50 W PEP output relative to a half-wave dipole onchannelized frequencies. As the QZ-60 is a half-wave dipole there is no need to figure out the gain of the antenna, as longas you don't input more than 50 W PEP you will remain legal.2. Drip Dam(optional) Helps prevent water/rain from running down the antenna wire to the operating position. Squeeze andslide the non-conductive Drip Dam over the open wire end before final insulator install.3. Installing insulator--thread wire thru per diagram below and it will self lock in place. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine