Quadratec 12057.0102 Installation Manual

Quadratec 12057.0102 Installation Manual Manual pdf 1 page image

The Trusted Source®Quadratec® Rock CrawlerFront BumperInstallation Manual for ’87-’06 Wrangler & Wrangler Unlimited#12057.0102PARTS LIST:FRONT BUMPER - QTY 1BUMPER SPACER PLATES - QTY 21⁄ 2 ” ZINC PLATED WASHERS - QTY 41⁄ 2 ”- 13 x 1 - 1⁄ 2 ” Grade 8 BOLTS - QTY 2REQUIRED TOOLS:SAFETY GLASSEST55 TORX HEAD SOCKETTORQUE WRENCHRequired Tools Note: Depending on what bumperyou currently have on your Jeep ® (factory or after-market) will determine exactly what wrench youwill need to remove and install your newQuadratec bumper.The T55 Torx wrench listed above is to removeand re-install factory bolts on a 97-06 Wrangler.Some Aftermarket bumpers use an oversizedPhillips Head or bolt type head.TO REDUCE RISK OF SERIOUS INJURY OR PROPERTY DAMAGE:READ ALL SAFETY MESSAGES AND UNDERSTAND ALLINSTRUCTIONS AND PROCEDURE NOTICES BEFOREATTEMPTING TO INSTALL OR USE THIS PRODUCT.MOUNT WINCH USING ONLY QUADRATEC APPROVED MOUNTINGPLATE. BUMPER/WINCH PLATE NOT INTENDED FOR WINCHES INEXCESS OF 9500LBS. LOAD LIMITS FOR YOUR BUMPER/WINCHMAY BE LESS DEPENDING ON CONDITION OF YOUR VEHICLEAND ATTACHMENTS. FOLLOW ALL INSTRUCTIONS, LIMITATIONS& WARNINGS WITH YOUR VEHICLE, THIS PRODUCT, YOURWINCH AND SAFE WINCHING PRACTICES SUPPLEMENT.RISK OF EYE INJURY! SAFETY GLASSES MUST BE WORN AT ALLTIMES WHILE INSTALLING OR MAINTAINING THIS PRODUCT.TORQUE AND RECHECK FASTENERS AFTER 250 MILES ANDFREQUENTLY THEREAFTER. INSPECT BUMPER, WINCH ANDMOUNT BEFORE USE. DO NOT USE IF DAMAGED.CHECK STATE AND LOCAL HIGHWAY SAFETY LAWS REGARDINGPERMITTED BUMPER TYPES AND HEIGHTS.