Quick Start Guide: QNET 2.0 HVACTo complete your QNET HVAC setup, you will also need the following hardware:1. Quanser QNET 2.0 HVAC board2. 24VDC, 2.7A Power SupplyCheck Components and DetailsSTEP 1Make sure your QNET HVAC experiment includes the following components:Additional Components RequiredInstall LabVIEW and Add-OnsSTEP 2STEP 3Make sure the following versions of LabVIEW™ and required add-ons are installed:1. LabVIEW™ 2012 or later2. NI DAQmx 9.5.5 or later3. NI ELVISmx 4.4 or later4. LabVIEW™ Control Design and Simulation Module 2012 or laterNote: The QNET curriculum resources areavailable for download at www.ni.com/qnets41 2 1. NI ELVIS II or NI ELVIS II+ workstation2. +5VDC / 5A, +15VDC / 2A,-15VDC / 0.8A Power Supply3. USB Cable4. Power Cable for the QNET 2.0 HVACpower supply (available throughNational Instrument based on yourcountry’s power/voltage requirements)Note: All references to NI ELVIS II inthis guide apply to both NI ELVIS IIand NI ELVIS II + devices.31 2