LTO-3, LTO-4, LTO-5, LTO-6, LTO-7 andLTO-8ContentsConnecting the Drive Interface and PowerCables .....................................................2Installing a Second Tape Drive orReplacing a Tape Drive ...........................4Preinstallation Requirements .............4Installation Procedure ........................4SCSI Cable Configurations ...............12Installing the 1U Rackmount Enclosure ina Rack ...................................................15Tools Required ..................................15Installation Procedure ......................15Completing the Installation .............22Class A Device Declarations..................241U Rackmount EnclosureInstallation GuideThe 1U Rackmount enclosure is provided with either one or two of thefollowing supported tape drives already installed:• LTO-3 (Model B) Half-Height, SCSI model TC-L33CX-EY-B• LTO-3 (Model B) Half-Height, SAS model TC-L33CN-EY-B• LTO-4 (Model B) Half-Height, SCSI model TC-L43CX-EY-B• LTO-4 (Model B) Half-Height, SAS model TC-L43CN-EY-B• LTO-5 Half-Height, SAS model TC-L53CN-AR• LTO-6 Half-Height, SAS model TC-L62AN-BR• LTO-7 Half-Height, SAS model TC-L72AN-BR• LTO-8 Half-Height, SAS model TC-L82AN-BRYou can upgrade a single-drive enclosure to the two-drive configuration byinstalling a second tape drive using any supported model of the same typeinterface.This guide references the instructions for installing the 1U Rackmountenclosure in an equipment rack, and provides the procedures for:• Connecting the drive interface and power cables• Installing a second tape drive into the 1U Rackmount enclosure