Quantum MKZ2 Instructions For Use Manual
  |
QUANTUM POWER MODULE MKZ2 & XKZ2U.S. PATENT# 4,988,584INSTRUCTIONSINTRODUCTIONModules MKZ2 and XKZ2 were specially designed for use with the Nikon SB24, SB25, SB26, SB27, SB28,SB28 Euro, Canon 540EZ, and 550EX.Module MKZ2-for use with the Quantum Battery 1/1+Module XKZ2-for use with the Bantam BatteryRead the following instructions thoroughly before proceeding.IMPORTANTDo not exceed the flash manufacturers maximum allowance of consecutive full-power flashes without lettingthe flash cool down for a minimum of 10 minutes. If no recommendation is given, do not exceed 36consecutive flashes without a 10 minute cool-down period.Instructions for:QUANTUM BATTERY1/1+ MODULE MKZ21. Turn the Quantum Battery 1/1+ OFF.2. Install the module into the flash as shown in the module location diagrams.3. Plug the module into one of the flash outputs on the Quantum Battery 1/1+.4. Turn the Quantum Battery 1/1+ on.If the flash does not power-up* within one second, turn the Quantum Battery 1/1+ OFF immediately**.Instructions for:BANTAM BATTERY MODULE XKZ21. Install the module into the flash as shown in the module location diagrams.2. Insert the plug of the module into the connector jack of the Bantam Battery.If the flash does not power-up* within one second, remove the plug from the Bantam Battery immediately**.NOTES:*You can tell if the flash is powered-up by checking to see if the LCD Panel on the flash becomes active, orby listening for the whine of the flash recycling.**If the flash does not respond, check to see if the module is correctly oriented inside the flash. If you stillhave difficulty, consult your dealer or contact us for assistance before proceding.SECURING THE MODULE1. Using plastic screwdriver (attached to cord) turn screw in module counterclockwise 3 turns, or until wedgesretract fully.2. Install module into the flash in correct orientation - see figures 1 & 2.3. Press module down firmly with finger and turn screw clockwise approximately 3 full turns, OR UNTILYOU FEEL SOME RESISTANCE. DO NOT OVERTIGHTEN.4. Pull module cord gently to assure that the module is secure.5. Optional: Secure the battery door with velcro as shown in figures 3 & 4. |
Related manuals for Quantum MKZ2
manualsdatabase
Your AI-powered manual search engine