Quark-Elec IS20 Setup Manual
Also see for IS20: Manual
  |
V1.0(05/23)IS20* NMEA 0183 input/output The NMEA 0183 input supports two different baud rates: 4.8kbpsand 38.4kbps. These baud rates can be selected from the settings page, allowing you to choosethe appropriate data source for the IS20. The selected data source provides real-time data to theIS20, which is then displayed on the screen for easy monitoring.Furthermore, the IS20 has the capability to transmit (repeat) data from the NMEA 0183 inputand send it to other devices using NMEA 0183 output wires. If you wish to forward the data to acomputer, you will need a TTL to USB adapter (not included). This enables the input data to bedisplayed on software running on your computer, enhancing data visibility and analysis capabili-ties.The IS20 input/output interface is based on NMEA 0183-RS422 (differential) protocol.For RS422 interface devices , connect ‘+’ to ‘+’ wire of IS20, and ‘-’ to ‘-’ wire of IS20. Swap ‘+’ and‘–’ wires if the IS20 does not work.For RS232 interface device( single end), connect TX/RX to NMEA input/output ’-’ and GND toinput/output ’+’. Swap TX/RX and GND wires if the IS20 does not work.Type-C connectorThe IS20 is supplied with a type-C USB connector and USB cable for settings and upgrade its firm-ware. The USB cable can be linked directly to a USB port on the Windows PC.NMEA 2000 connectorThe IS20 provides a standard male NMEA 2000 connector. It can also be connected to a NMEA2000 network to receive NMEA 2000 data. The NMEA 2000 connector also provides the powersupply to IS20.Disclaimer: This product is designed to aid navigation and should be used to augment normal navigational proceduresand practices. It is the user’s responsibility to use this product prudently. Neither Quark-elec, nor their distributors ordealers accept responsibility or liability either to the product user or their estate for any accident, loss, injury ordamage whatsoever arising out of the use or of liability to use this product.GETTING STARTEDTurning the unit on and offThe IS20 offers two options for powering the device: through the N2K connector or the powercable connected to the Power and NMEA 0183 input/output connector. Once power is supplied,press and hold the POWER button for 3 seconds to turn on the screen. The Quark-elec logo willbe displayed, followed by a legal notice page upon completion of the initialization process. Toproceed, simply tap 'Accept', and the default page will be presented.To power off the IS20, press and hold the POWER button for 5 seconds while the display is active.Adjust the brightnessWhen the IS20's screen is active, pressing and holding the central area of the screen will bring upthe brightness setting page. From this page, you can conveniently adjust the screen brightness toyour desired level, ensuring optimal visibility in different lighting conditions.SetupFor more details on how to setup IS20 and operation, please refer to the manual, which can befound on the Quark-elec website.SET-UP GUIDEIS20 NETWORKEDMULTIFUNCTION INSTRUMENTAll products are CE, RoHS certifiedPlease recycle your packagingDash mountingFlush mounting |
Related manuals for Quark-Elec IS20
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine