6. WiFi Ad-hoc connectionOn your device (phone, laptop etc.):15 seconds after the A033 has powered up, youcan scan for a WiFi network with an SSID similar to‘QK-A033xxxx’. Connect to ‘QK-A033xxxx’ withthe default password: ‘88888888’.Chart software: in your chart software, set theprotocol to ‘TCP’, IP address to ‘192.168.1.100’and port number to ‘2000’For Station mode WiFi setup, use the Configura-tion software. (see below)Disclaimer: This product is designed to aid navigation and should be used to augment normal navigationalprocedures and practices. It is the user’s responsibility to use this product prudently. Neither Quark-elec, northeir distributors or dealers accept responsibility or liability either to the product user or their estate for anyaccident, loss, injury or damage whatsoever arising out of the use or of liability to use this product.Email: info@quark-elec.comV1.1(10/19)QK-A033Note: SeaTalk™ is a registered trademark of Raymarine.USING THE CONFIGURATION SOFTWARE (WINDOWS):WiFi can be changed from Ad-hoc (default) to Station mode or Standby.Station mode is configured by inputting your router/access point’s details into the Configurationsoftware. (once configured, the correct settings must be entered into your chart software.)Filtering: using the black list functionIf desired, selected NMEA sentences can be blocked from chosen input/s, using the ’black list ‘field. Remove the ‘$’ or ‘!’ from the 5 digit NMEA talker and sentence identifier and insert sepa-rated by commas. For example to block ‘!AIVDM’ and ‘$GPAAM’ enter ‘AIVDM,GPAAM’ .Up to 8 sentences types can be filtered from each input port. If blacklisting Seatalk data, blockthe corresponding NMEA message (see the manual for a full list of converted messages).Routing the Seatalk and NMEA sentences.As a default, all inputs’ data (excluding any filtered data) is routed to all outputs (NMEAx2, WiFiand USB). Data can be routed to limit the data flow to only certain output/s by un-ticking thecorresponding boxes in the Configuration software.NMEA Baud rates: Default Baud rates are set to: NMEA IN 1 and 2: 4800bps NMEA IN 3: 38400bps NMEA OUT 1: 4800bps NMEA OUT 2: 38400bpsThese can be changed as required.USB input: The USB connection is 2 way as standard, no additional configuration required. Man-ual NMEA input via USB is also possible through the configuration software. A good understand-ing of NMEA sentence structure is required for this additional function.SET-UP GUIDEQK-A033WIFI/USB/NMEA 0183 MULTIPLEXERWITH SEATALK™ CONVERTERAll products are CE, RoHS certifiedMore information at www.quark-elec.comPlease recycle your packaging