Package ContentsWarnings and Cautions1of3For Style DRS8407EKTurn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We stronglyrecommend that a licensed, professional electrician perform the installation.Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.ACrossbarAssemblyx 1Please go to for product cleaning tips. Go to the selection.(1) A19 Medium Base Bulb 100W Maximum, Medium Base Vintage Bulb is recommended, bulb not included.20-30 minutesIdentify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts arepresent. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact your original place of purchase.www.quoizel.com Care + MaintenanceLight Source:Estimated Assembly Time:Preparation:Fixture can only be mounted in the direction indicated on page 2.Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.Fixture Bodyx 1CInstallation Guide #IS-DRS8407EK2019 QuoizelInc. ReleasedDate:2019-03-15visit us on-line at www.quoizel.comBAlternateMounting screwx 2D ETabx 4 Glass Panelx 4STEP 2 Install Bulb-A. Insert the bulb onto the socketand screw snugly into place.SocketVintage Bulb(recommendedbut not included)Figure 2STEP 3 Install Glass Panels-A. Place the Glass Panel (D) into the slotin the bottom edge of the cage. Securethe Glass Panel (D) by pressing theTab (C) onto the top edge of the GlassPanel (H) and the slot on the top edgeof the cage.DCSlotSlotFigure 3STEP 4 Install Cage and Arm toFixture Body-A. Place the cage over the bulb, attachto the fixture hood on the FixtureBody (E) and secure with previouslyremoved screws. Hand tighten untilsnug with screwdrivers.B. Place bolts on the bottom end of thearm to holes on the bottom edge ofthe cage and secure with previouslyremoved lock balls. Hand tightenuntil snug.Figure 4BoltHoleSTEP 1 Remove Arm and Cage-A. Unlock lock balls in the bottom edgeof the cage and remove the arm fromthe Fixture Body (E).B. Unscrew screws on the top edge ofthe cage and remove the cage fromthe Fixture Body (E).ArmScrewCageLock BallEFigure 1CageArmEScrewCageLock Ball