Quoizel HGN8406WT Installation Manual

Quoizel HGN8406WT Installation Manual Manual pdf 1 page image

Package ContentsWarnings and Cautions1of2For Style HGN8406WTTurn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We stronglyrecommend that a licensed, professional electrician perform the installation.Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.Please go to for product cleaning tips. Go to the selection.(1) A19 Medium Base Bulb 100W Maximum, Medium Base Vintage Bulb is recommended, bulb not included.20-30 minutesIdentify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts arepresent. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact your original place of purchase.www.quoizel.com Care + MaintenanceLight Source:Estimated Assembly Time:Preparation:Fixture can only be mounted in the direction indicated on page 2.Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.Fixture Bodyx 1CSTEP 1 Installing the Crossbar Assembly-A. Pass the supply wires through the Crossbar Assembly (A). Attachthe Crossbar Assembly (A) to the Outlet Box with the head of theGreen Ground Screw facing you. Secure the Crossbar Assembly (A)with Outlet Box Screws (not included). Tighten until snugNote: Use the Alternate Shorter Mounting Screw (B) if yourinstallation requires a shorter mounting screw.. STEP 3 - Wire ConnectionsA. Wrap bare or green ground wire around green ground screw on thecrossbar, no less than 2 inches from the end of the wire. Tighten thegreen ground screw.B. Use standard wire connectors (not included) to make all wireconnections. Twist connectors until wires are tightly joined together.Wrap each connection with approved electrical tape and carefullystuff all the connected wires into the Outlet Box.Figure 3Green Ground Screwon the CrossbarWhite wirefrom outlet box White wirefrom fixtureBlack wire fromoutlet box (or Red)Black wirefrom fixtureBare, or GreenGround wirefrom outlet boxGround wirefrom Fixture(Step 2 Continued)out of the crossbar until the correct length is achieved. Once thebackplate and Fixture Body (C) is secure, remove the mountingball and Fixture Body (C) and proceed to Step 3.Installation Guide #IS-HGN8406WT2019 QuoizelInc. ReleasedDate:2019-03-22visit us on-line at www.quoizel.comSTEP 2 Test Fit the Backplate to the Crossbar Assembly-A. Remove the mounting balls from the Crossbar Assembly (A). Placethe backplate and Fixture Body (C) onto the Crossbar Assembly (A)and secure with mounting balls. Note: The backplate and FixtureBody (C) should be snug against the wall and held tight with themounting balls. If it is not, adjust the length of the mounting screwson the Crossbar Assembly (A) by unscrewing the preassembled hexnut and lock washer and then screwing the mounting screws in orACrossbarAssemblyx 1BAlternateMounting screwx 2Glass Shadex 1DSocket Collarx 1EFigure 1Mounting Screwor Alternate ShortMounting ScrewSupply Wireswith Ground WireOutlet Box Screws(not included)Outlet BoxAMounting BallABackplateHex Nut andLock WasherCMounting Screwor Alternate ShortMounting ScrewFigure 2

/ 2

Related manuals for Quoizel HGN8406WT