Quoizel WWD8408IB Installation Manual

Quoizel WWD8408IB Installation Manual Manual pdf 1 page image

Package ContentsWarnings and Cautions1of2For Style WWD8408IBTurn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We stronglyrecommend that a licensed, professional electrician perform the installation.Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.ACrossbarAssemblyx 1Please go to for product cleaning tips. Go to the selection.(1) A19 Medium Base bulb 100W Maximum, bulb not included.20-30 minutesIdentify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts arepresent. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture.www.quoizel.com Care + MaintenanceLight Source:Estimated Assembly Time:Preparation:Fixture can only be mounted in the direction indicated on page 2.Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.Missing Parts? Contact your original place ofpurchase.Fixture Bodyx 1 BSTEP 4 - Wire ConnectionsA. Wrap bare or green ground wire around green ground screw on thecrossbar, no less than 2 inches from the end of the wire. Tighten thegreen ground screw.B. Use standard wire connectors (not included) to make all wireconnections. Twist connectors until wires are tightly joined together.Wrap each connection with approved electrical tape and carefullystuff all the connected wires into the Outlet Box.Figure 4Green Ground Screwon the CrossbarWhite wirefrom outlet box White wirefrom fixtureBlack wire fromoutlet box (or Red)Black wirefrom fixtureBare, or GreenGround wirefrom outlet boxGround wirefrom FixtureSTEP 3 Test Fit the Backplate to the Crossbar Assembly-A. Remove the mounting balls from the Crossbar Assembly (A). Placethe backplate and Fixture Body (B) onto the Crossbar Assembly(A) and secure with mounting balls. Note: The backplate andFixture Body (B) should be snug against the wall and held tightwith the mounting balls. If it is not, adjust the length of themounting screws on the Crossbar Assembly (A) by unscrewing thepreassembled hex nut and lock washer and then screwing theSTEP 1 Remove Styrofoam insideof the Cage-Styrofoam(Remove)Figure 1STEP 2 Installing the Crossbar Assembly-A. Pass the supply wires through the Crossbar Assembly (A). Attachthe Crossbar Assembly (A) to the Outlet Box with the head of theGreen Ground Screw facing you. Secure the Crossbar Assembly (A)with Outlet Box Screws (not included). Tighten until snug.Supply Wireswith Ground WireOutlet Box Screws(not included)Outlet BoxAFigure 2MountingBallABackplateHex Nut andLock WasherMounting ScrewBFigure 3mounting screws in orout of the crossbar untilthe correct length isachieved. Once thebackplate and FixtureBody (B) is secure,remove the mountingball and Fixture Body (B)and proceed to Step 4.CageInstallation Guide #IS-WWD8408IB2018 QuoizelInc. ReleasedDate:2018-04-04visit us on-line at www.quoizel.com

/ 2

Related manuals for Quoizel WWD8408IB