RADSON CONFORT PILOT Installation And Use Manual
Also see for CONFORT PILOT: Guide for installation and use
      | |
Contents | 
1ENGGuide for installation and use CONFORT PILOTAfter connecting your appliance to the electrical installation,turn on the appliance by pressing the button [B].The indicator light [C] will light up.Function buttons:A Temperature control [indicator light colours: frostoutside [*] - yellow; ECO - green; 18°C to max. - red].Used to engage the “Confort Pilot” function.B ON/stand-by button, thermostat and 2-hr. timer.C Radiator control light [green indicator light].D Indicator light for the 2-hr timer [red indicator light].THERMOSTAT CONTROLTo select the desired [or recommended] temperature:• Press the [+] or [-] button [A].- The thermostat indicator light will begin toflash if the room temperature is lower than thedesired temperature: the appliance will start.- When the desired temperature has beenreached, the thermostat indicator light [C]will stop flashing and will burn steadily: theappliance will stop.The appliance starts as soon as the room temperatureis lower than the recommended temperature.USING THE TIMER TO ADJUST THETEMPERATUREWith this function, you can warm up a room or drylaundry for 2 hours. The appliance thermostat doesnot operate during that time [the recommendedtemperature indicator light is off].The timer indicator light will burn until the 2 hoursare over. The appliance will then return to normaloperation [thermostat-control of the room tempera-ture] when the timer goes out.To activate the timer:• Press briefly on the button:- The timer indicator light [D] will light up and the2-hour heating cycle will start.The timer indicator light will flash until the endof the cycle.Note: you can interrupt the timer at any time bypressing 2 times quickly on the button.To activate the “Confort Pilot” function:With this function, you can programme the timer torepeat a specific heating function every day at thesame time.• Activate the timer [as explained below].• Press on the desired time by pressing the [+] but-ton for 5 seconds to register that you are activatingit [the red indicator light will flash].- The heating will start immediately for 2 hoursand will repeat after 23.15 hours and thereafterevery 24 hours.Example: on the 1st morning, the user pushes the[+] button for 5 seconds at 7.00 o’clock in timermode. The next day, and for every day thereafter, theappliance will start at 6.15 a.m. and run for 2 hours.Note:• You can interrupt the timer at any time by pressing2 times quickly on the button.• To cancel the programme, press the [+] button intimer mode for 5 seconds.CALIBRATING THE THERMOSTATA difference of 1° C to 2° C between the referencetemperature on the housing and the temperaturethat is measured by a thermometer is normal.If you want those 2 values to be identical, you can dothe following:• Measure the room temperature with a thermo-meter;• Press on the and [+] buttons for at least 5seconds at the same time.- The temperature indicator light and the ‘frostoutside’ indicator lights will both begin to flash.• If the temperature on the display is not the sameas the temperature shown on the thermometer,press the [+] or [-] button to adjust the tempera-ture shown to match the room temperature.• To set the new values, press briefly on thebutton.• Example: the display shows 20° C and thethermometer shows 22° C. Press the [+] buttonuntil the display shows 22° C. |
Related manuals for RADSON CONFORT PILOT
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine