RCL DR2 Installation Instructions Manual
     |
READ INSTRUCTIONS CAREFULLY BEFORE USINGTHIS PRODUCT. SAVE INSTRUCTIONS FORLATER REFERENCE.PRODUCT IS NOT SUITABLE FOR PHASE DIMMINGProducts must be installed by a suitably qualifiedprofessional only. Installations must conform to nationalinstallation codes and accident prevention regulations.If using a track adaptor, ensure it is compatible with thetrack system installed. Failure to do so may result indanger of electric shock and damage to the product.Ensure electrical rating shown on product labelconforms to mains voltage supply.Do not modify the product in any way. RCL acceptsno responsibility for damage caused by modifyingthis product.Product is rated IP20 unless otherwise stated. Installindoors only and away from damp or wet environments.This symbol indicates the minimum distance to alighted object and must be observed.Caution, product will become hot in use. Allow to coolbefore touching.Dispose of this product in accordance with WEEE orother national regulations.Products marked with this symbol are compliant withClass 2 regulations.If you have any difficulty installing this productplease contact:Remote Controlled Lighting Ltd (UK)42 Riverside Road, London SW17 0BA+44 (0) 20 8404 2400tech@rclighting.comRemote Controlled Lighting Ltd (Asia)Unit 13, 8/F, Lai Sun Yuen Long Centre21-35 Wang Yip Street East,Yuen Long, Hong Kong+852 2310 9733Installation InstructionsRemote Controlled Spotlight Type DR2Important Safety InformationDOC-033-CCopyright © 2016 Remote Controlled Lighting Ltd. All Rights Reserved.BEFORE YOU STARTRead these instructions carefully. For the latestinstructions on all our products seewww.rclighting.com/downloadsThese instructions cover the followinginstallation methods:Monopoint Installation3-Circuit Installation2-Circuit Installation1-Circuit InstallationHook Clamp InstallationLamp Change - QR111Accessory Change - QR111ABCDEFG14567The monopoint fixture requires a minimum clearancedistance of 200mm above and around the mountingpoint and a maximum ceiling material thickness ofbetween 3mm and 35mm.2 Mark up the ceiling and cut a circular hole 115mm indiameter.3 For multiple installations, ensure a minimum distanceof 400mm between mounting points.AMonopoint InstallationPAGE 1Insert the mounting ring into the hole so that it sitsflush with the ceiling.Holding the mounting ring in place, insert a fixing clipinto a slot on the mounting ring.Slide the fixing clip down the slot until it hits theceiling material.Insert fixing studs into mounting ring holes and, usinga 2.5mm hex screwdriver, secure the clip in place.Repeat this process for each fixing clip.200mm MIN.200mm MIN.Ø3 - 35mm115mm400mm MIN. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine