RCL DR8 Mk2 Installation Instructions Manual
READ INSTRUCTIONS CAREFULLY BEFORE USINGTHIS PRODUCT. SAVE INSTRUCTIONS FORLATER REFERENCE.PRODUCT IS NOT SUITABLE FOR PHASE DIMMINGProducts must be installed by a suitably qualifiedprofessional only. Installations must conform to nationalinstallation codes and accident prevention regulations.If using a track adaptor, ensure it is compatible with thetrack system installed. Failure to do so may result indanger of electric shock and damage to the product.Ensure electrical rating shown on product labelconforms to mains voltage supply.Do not modify the product in any way. RCL acceptsno responsibility for damage caused by modifyingthis product.Product is rated IP20 unless otherwise stated. Installindoors only and away from damp or wet environments.This symbol indicates the minimum distance to alighted object and must be observed.Caution, product will become hot in use. Allow to coolbefore touching.Dispose of this product in accordance with WEEE orother national regulations.Products marked with this symbol are compliant withClass 2 regulations.If you have any difficulty installing this productplease contact:Remote Controlled Lighting Ltd (UK)42 Riverside Road, London SW17 0BA+44 (0) 20 8404 2400tech@rclighting.comRemote Controlled Lighting Ltd (Asia)Unit 13, 8/F, Lai Sun Yuen Long Centre21-35 Wang Yip Street East,Yuen Long, Hong Kong+852 2310 9733Installation InstructionsRemote Controlled Spotlight Type DR8 Mk2Important Safety InformationDOC-260-ACopyright © 2016 Remote Controlled Lighting Ltd. All Rights Reserved.BEFORE YOU STARTRead these instructions carefully. For the latestinstructions on all our products seewww.rclighting.com/downloadsThese instructions cover the followinginstallation methods:3-Circuit Installation2-Circuit Installation1-Circuit InstallationMonopoint InstallationTrough InstallationLamp Change - QR111Lamp Change - HIR111-CE-PLamp Change - HIT-CEAccessory ChangeSnoot InstallationABCDEFGHIJ123456Ensure that the track system where the DR8 luminaireis to be installed is compatible with the Eutrac3-Circuit adaptor.A3-Circuit Track InstallationIf the spotlight is to be controlled via DMX or DALI,ensure that track system includes Data Bus. See Formore information on DMX Installation see DOC-083.NOTES231N*note orientationInsert the track adaptor into track system. Take careto avoid any fixing screws holding the track onto theceiling.To mount the track adaptor into the track system, firstcheck that both the selector knob and the adaptorlock are disengaged, as shown below.Rotate selector knob to the desired circuit position(see section 7).Rotate adaptor lock clockwise 90° to connect theadaptor to the neutral circuit.When installing the adaptor into the track, ensure thatit is orientated correctly. Align the tabs with theslot on the track.PAGE 1 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine