Install Guide CT110Caution• Turn off electricity to the HVAC system before installing orservicing thermostat or any part of the system.• Do not turn electricity back on until work is completed.• Do not short (jumper) across electric terminals at the controlon the furnace or air conditioner to test the system. This maydamage the thermostat.• All wiring must conform to local codes and ordinances.• This thermostat is designed for use with 24 volt AC HVACand millivolt gas systems. The thermostat is powered by 4AAalkaline batteries and/or 24 volt AC C wire (or a 12-24 AC orDC source). Each thermostat relay load should be limited to 1.0amp; higher amperage may cause damage to the thermostat.• Your thermostat is a precise instrument, handle it with care.Caution To avoid electrical shock andto prevent damage to the furnace, air conditioner, andthermostat, disconnect the power supply beforebeginning work. This can be done at the circuit breaker.1308-001-001INSTALLATIONENGLISHTemperatureadjust buttonsZ-Wave joinButtonIndicatorsLCD screenMODEbuttonResetButtonFANbuttonWall PlateandWall plate frameThermostat