Radionics D9133TTL-E Installation Instructions Manual
  |
D9133TTL-E Serial Interface Module Installation Instructions© 1999 Radionics Page 1 41124B 3/99D9133TTL-E Ethernet Interface ModuleInstallation InstructionsDescriptionThe D9133TTL-E is an SDI bus device for use with the 9000/7000 Series Control/Communicators (D9412, D9112,D7412, D7212). The D9133TTL-E is used for bi-directional communications over Ethernet networks which are typicallyused for event reporting and remote programming.LED Enable Jumper (P2)SDI Bus ConnectionTerminal StripEthernet InterfaceIndicator LEDsAddress Jumpers1 2 4 8LEDsEthernet Link LEDFigure 1: D9133TTL-E Circuit Board LayoutSpecifications• Dimensions: 7 inches x 4.5 inches (17.8 cm x 11.4 cm)• Current Draw: 500 mA• Compatibility: D9412, D9112, D7412, D7212 Control/Communicators with firmware version 05.22 and higher• Connectors: Control Panel: SDI Bus Terminal StripLAN/WAN: 'RJ' Modular Jack (Ethernet)Installation1. Remove AC and battery power from the Control/Communicator.2. Wire the D9133TTL-E to the Control/Communicator asindicated in Figure 2 and in the table below.Control/Communicator D9133TTL-ESDI PWR (Terminal 32)SDI A (Terminal 31)SDI B (Terminal 30)SDI COM (Terminal 29)SDI PWRSDI ASDI BSDI COMNOTE: SDI device wiring is limited to 1,000 feet (304.8 meters).3. Connect an Ethernet cable to the Modular Jack labeled Ethernet.4. Set up the D9133TTL-E as described on page 2.5. Reconnect AC and battery power to the Control/Communicator and power up the system.D9133TTL-EPERIPHERAL DEVICE WIRINGREDYELLOWGREENBLACKPOWER +DATA BUS ACOMMONDATA BUS B31303229Control/CommunicatorFigure 2: Wiring the D9133TTL-E |
Related manuals for Radionics D9133TTL-E
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine